全部

1·This measurement will give you the propeller shaft Angle (C).

测量结果就是传动轴工作角(c)。

2·Aligning intermediate shaft and propeller shaft after launching.

下水后中间轴和螺旋桨连接后校中。

3·In this step, work to drill for the pipe of a propeller shaft or a rudder.

在这个步骤中，演练工作，为管道的传动轴或舵。

4·Most cars have two universal joints, one at each end of the propeller shaft.

多数 汽车采用两个万向节，在传动轴的每一端各有一个万向节。

5·Therefore, the optimizing of propeller shaft bracket is a very important issue.

因此，船舶尾轴架结构的优化设计是一个很重要的问题。

6·The propeller on the propeller shaft is located outside the rudder propeller housing.

螺旋桨轴上的螺旋桨位于所述舵桨壳体的外部。

7·Inspection machining dimension of propeller shaft (intermediate shaft or counter shaft).

螺旋桨轴(中间轴)机加工尺寸检查。

8·These drive the central propeller shaft through bevel reduction gears with a 2:1 reduction.

这些驱动器，中央螺旋桨轴通过减少锥齿轮2：1减少。

9·The propeller shaft frequency is one of the important target recognition features for passive sonar.

螺旋桨轴频是被动声纳极其重要的目标识别特征之一。

10·The driving power enters the differential through the drive pinion on the end of the propeller shaft.

也就是说，驱动力是从传动轴末端的传动齿轮输送到差速器的。

传动轴

1·The driving power enters the differential through the drive pinion on the end of the propeller shaft.

也就是说，驱动力是从传动轴末端的传动齿轮输送到差速器的。

2·Abnormal noise often occurs in motor vehicle transmission system especially in propeller shaft and final reduction gear.

汽车传动系特别是传动轴与主减速器常产生异常响声。

3·In this paper, the correct assembly condition for the propeller shaft of an articulated vehicle is analyzed in the view of kinematics.

从运动学观点分析铰接式车辆传动轴的正确安装条件；

4·Most cars have two universal joints, one at each end of the propeller shaft.

多数 汽车采用两个万向节，在传动轴的每一端各有一个万向节。

5·The engine acts as the power unit located normally at the front of the car, followed immediately by a clutch, gear box, propeller shaft, universal joint , differential, back axle, etc.

发动机是提供动力的组件，一般装在汽车的前面，紧接着离合器、变速器、传动轴、万向接头、差速器、后车轴等等。