全部

1·There was oil leakage along the Gulf Coast.

墨西哥湾沿岸有石油泄漏。

2·Do oil leakage check to engine.

对发动机进行机油泄漏检查。

3·It can prevent air leakage and oil leakage efficiently.

能有效的起到密封，防止漏油、漏气作用。

4·The Marine environment here has deteriorated due to crude oil leakage.

因为发生原油泄漏，这里的海域环境恶变。

5·Simultaneously the sealing structure is improved to prevent the oil leakage.

同时改进密封结构，防止漏油。

6·Do not resume operation until cause of oil leakage has been revealed and excluded.

在漏油原因发现并且排除前，不可以恢复操作。

7·Oil leakage often easily happens to the needle stems when machines are running at great speed.

机器在高速运转中，针杆部极易发生渗油现象。

8·The crude oil was properly heated and oil leakage was minimized through strengthened management.

加强管理力度，减少粘油泄漏等。

9·Causes for oil leakage at oil depots are analyzed and measures to prevent the accident are presented.

对油库跑冒油事故发生的原因进行了分析，提出了防止跑冒油事故的措施。

10·Through taking the measures for the reducer oil leakage, the problems of speed reducer leakage are solved.

通过对漏油减速机实施相应改造与防治，基本解决了减速机漏油的问题。

漏油

1·Oil leakage often occurs in reducer due to its blowhole of ventilator jams for a short time while reducer operating under excessive dust condition.

高粉尘环境下工作的减速器，经常因其上的通气器通气孔堵塞（短时间内）而引起漏油现象。

2·The main reasons to the rotary air pre-heater secondary combustion are related to unstable oil gun combustion, internal oil leakage and insufficient soot-blower steam pressure, etc.

锅炉回转式空气预热器发生二次燃烧的主要原因与油枪燃烧不稳定、内部有漏油和吹灰蒸汽压力不够等相关。

3·The application of liquid location sensors of magnetostriction in the liquid location measurement and oil leakage alarm of hydraulic station are introduced in this paper.

介绍了磁致伸缩液位传感器在液压站油箱液位测量和漏油报警中的应用。

4·In 2009, water ingress and oil leakage accidents frequently occurred on the backup oil film bearing in no. 2 Rolling Plant of Angang, which severely restricted the normal production of the mill.

2009年，安钢第二轧钢厂频繁出现支承辊油膜轴承进水和漏油事故，严重制约了轧机的正常生产。

5·Built-in relieve value, prevent damaging the main unit and oil leakage caused by shutting the door by strong pressure or wind.

内置减压阀，防止因外来强压或强风状态下闭门而造成的主机损坏或漏油。