全部

1·The end of the injection tube is provided with a dispersion device such as a porous plug or fritted glass.

注射管的末端提供有分散装置例如多孔塞或烧结玻璃。

2·It also provides an indication of common issues such as plugged injection point, ruptured or worn tube or empty solution tank and assists with impeding backflow.

也可提供一些通用的指示数据，比如塞进的注射点，破裂管或空的溶液槽以及阻碍回流等。

3·Conclusion cervical disc herniation treatment with cervical epidural lateral interspace implanted tube collagenase injection method is more reliable compared with direct injection method.

结论颈部硬膜外侧间隙置管注射胶原酶治疗颈椎椎间盘突出症疗效确切，优于直接注射法。

4·The paper introduces the structure and design characteristics of the heat runner injection mold for one kind of beverage bottle parison tube.

介绍了一种饮料瓶坯管热流通注射模的结构及设计特点。

5·Introduced the structure of medical soft plastic tube; and technology analysis; and structure design of injection mold and mold work principle.

介绍了医用软管塑件结构、工艺分析、注射模结构设计及模具工作过程。

6·The following factors were considered in heat loss calculating model, namely various valves, elbows, compensator, tube diameter, various injection conditions and injecting pipe's eccentric structure.

模型考虑了注汽管线上各种阀门、弯头、补偿器、异径管的影响，考虑了变注入工况和注汽管偏心结构对热损失的影响。

7·Tube plate method, tube dilution method and viable count method were used to determine the inhibitory activity of traditional Chinese medicine injection in vitro, such as Houttuynia Cordata Thunb etc.

采用管碟法、试管法、活菌计数法对鱼腥草等中药注射液体外抗菌活性进行测定，结果表明采用活菌计数法，用原液可以测出用管碟法所不能测出的中药抑菌作用。

8·This paper aimed at the injection forming of a kind of thin and long plastic tube, and it also gives a successful example of one mould for four parts and loop injection.

针对一种细、长且薄的管状零件的注塑成型，给出了一种一模四件、环形浇注的成功实例。

9·Study on interfacial tension, composition, density, viscosity and saturation of gas pha - se and liquid phase front in the slim tube under various injection pressures and injection rate.

分别研究了不同注入压力和注入气量下，细管中注气混相驱前缘和过渡带中气液两相的界面张力、组成、密度、粘度及饱和度的变化情况。

10·The single tube respective jet grouting, enlarging nozzle diameter and specific slurry injection technology are proposed.

提出采用单管分喷工艺、增大喷嘴直径以及特殊注浆工艺等方法。