全部

1·The tensile modulus showed a negligible change with thermal oxidation temperature.

模量随热氧化温度变化不明显。

2·An analytical algorithm to estimate the tensile modulus of Brazilian disk splitting tests is presented.

提出巴西圆盘劈裂试验中拉伸模量的解析算法。

3·Meanwhile, as the curing temperature increases, the tensile modulus of composites improves in some degree.

然而复合材料的拉伸模量随着成型温度的升高有一定幅度的提升。

4·The tensile modulus approximately equal to the compressive modulus of elasticity within the proportional limit.

拉伸载荷模量约等于比例极限内的弹性模量。

5·With VP-501 content increasing, the fracture toughness was increased, while the tensile modulus was decreased at both RT and 77 K.

随着VP-501含量的增加，体系在RT和77 K下的断裂韧性增加了，然而其拉伸模量降低了。

6·The results show that tensile strength and tensile modulus increase and cold-resisting property descends with temperature dropping.

结果表明，随着温度的降低，该橡胶的拉伸强度、拉伸模量升高，耐寒性下降；

7·The tensile strength, bending strength, impact strength, tensile modulus of elasticity and bending modulus of elasticity were determined.

测试了塑木板材的拉伸强度、弯曲强度、冲击强度、拉伸弹性模量、弯曲弹性模量等力学性能；

8·This article introduces a method to determine the plastic membrane tensile modulus by using a normal mart electron tensile testing machine and computers.

文章介绍了一种利用普通的智能电子拉力试验机配以计算机来计算塑料薄膜拉伸弹性模量的方法。

9·The effects of the content and dispersion of carbon nanotubes on the tensile strength, tensile modulus and ratio of elongation of the nanocomposites were studied.

研究了碳纳米管的加入量与分散程度对复合材料的拉伸强度、拉伸模量、断裂伸长率的影响。

10·In the bulk system, tensile strength, tensile modulus and impact strength are improved by 32.2%, 60.3% and 68.6%, respectively, without the loss of light transmittance.

而本体法复合材料的拉伸强度、拉伸模量及冲击强度值最大分别提高了32.2％、60.3％和68.6％，而透光性能基本未受影响。