全部

1·The Head gasket fails due to design flaws, rather then fragility.

垫片坏掉是由于设计上的缺陷，而不是本身的工艺问题。

2·The results expatiated that the strength of such cylinder head gasket meet the need when being used.

结果表明，此气缸垫的强度满足使用要求。

3·Although people seem to think there is an inherent weakness in the Head gasket in fact that's not true.

虽然人们似乎认为缸盖垫片存在着固有的弱点，但其实并不是这样。

4·An engine cylinder head gasket leaking between a cylinder and an adjacent water jacket is indicated by coolant foaming or overheating and loss of coolant.

在一个汽缸和相邻的水套之间的引擎汽缸头套环泄漏的标志是冷却液冷却液产生泡沫或者过热，并且冷却液流失。

5·Increasedcondensation by short distance driving below 20 km or a defect in the watercircuit (cylinder head gasket or flange connections) with entry of coolingwater.

由于低于20公里的短途行驶或者因为冷却系统（汽缸垫或法兰连接）的缺陷让冷却水进入，导致冷凝水增加。

6·Carburetor gasket seal, small general gasoline engine sealing, air filter separator device sealing, sealing, crankcase sealing, cylinder head gaskets, insulation gasket, exhaust pipe sealing.

小型通用汽油机用垫片，化油器密封，隔板器密封，空气滤清器密封，曲轴箱密封，汽缸头垫片，隔热罩垫片，排气管密封。

7·Generally, the cylinder and the cylinder head bolt together with a thin gasket pressed between them to ensure a good seal.

一般来说，气缸和气缸盖用螺栓紧固在一起，气缸与气缸盖之间用一薄垫圈确保密封良好。

8·When the gasket is placed on the block and the head installed, tightening of the head bolts squeezes the soft metal so that the joint is effectively sealed.

当气缸垫装在气缸体上，然后装上气缸盖以后，气缸盖螺栓就压紧软金属垫，这样结合处就完全密封了。

9·The features and principles of the double tightening method for cylinder head bolts is introduced to insure the uniform pressure on cylinder gasket during assembling operation.

介绍了装配作业中可确保发动机气缸盖全部螺栓对气缸垫压力均等的二次紧固的特点和原理。

10·Teflon - lined pipe, casing, elbow, the three exchanges or four, size head, cylinder, air compressor - oxygen - ring, gasket seal ring and auto parts.

聚四氟乙烯内衬直管， 套管，弯头，三通，四通，大小头，筒体，空压机-制氧机- 活塞环、密封圈和汽配封圈。