全部

1·The GAL is applied to ORed circuit . Matched circuit and ADDed circuit which are used in the BES Track Trigger System.

本文简要介绍在北京谱仪触发判选的径迹系统中采用GAL器件作相“或”电路、符合配对电路及径迹数相加电路。

2·Guarding implies the use of an added low impedance conductor, maintained at the same potential as the high impedance circuit, which will intercept any interfering voltage or current.

而保护意味着使用保持在与高阻抗电路相同电位的附加的低阻抗导体来阻止可能的干扰电压或电流。

3·To prevent the mistakes of operating ICC, infrared transmit-receive circuit is added in the contactless ICC reader design now.

为了从根本上防止刷卡出错，在非接触ic卡读卡器硬件设计上加入红外发射接收电路部分。

4·A novel ZVT power factor correction circuit is proposed, in which the saturable core and the-capacitor are added to the auxiliary switching network.

提出一种新型ZVT功率因数校正电路，将饱和电感和并联电客加入辅助开关网络中。

5·Shunt trip Shunt trip is a feature added to a circuit breaker or fusible switch to permit the remote opening of the breaker or switch by an electrical signal.

分励脱扣分励脱扣是线路断路器或可熔电闸的一个特性，可通过远程信号来进行分断或转换。

6·This paper introduces an advanced ZVT BOOST circuit. In order to enhance the efficiency, a lossless snubber circuit is added for auxiliary switching.

介绍一种改进型ZVT BOOST电路，辅助管增加了无损吸电路，进一步提高了软开关电路的效率。

7·A filtering net and a protective circuit of input are added in the front of input net, and a practical protective circ uit of output is also added.

在输入端加入了滤波网络和输入保护电路，并加入了实用的输出保护电路。

8·This paper introduces an ignition system with knocking eliminator consisting of a detonation sensor and a simpler controlling circuit added to a traditional ignition system.

本文提出一种只需在传统点火系中增加一只爆震传感器和简单的控制电路便可构成爆震推迟的点火系统。

9·Because of introduction of the additional switch, the control circuit of the converter becomes complex and the amount of the added parts and cost increases.

但是有源软开关技术因为有辅助开关管的引入，控制电路比较复杂，增加的额外元器件较多，变换器成本增加。

10·The element transition of thick and thin grid was restricted with inside mode, displacement restriction was added at end of circuit board.

粗细网格用内插约束单元过渡，电路板端添加位移约束。