全部

1·Simplified distribution levels: According to the power supply voltage levels.

简化配电的层次：如按的电压等级供电。

2·The power supply voltage line includes an edge part formed in an obtuse Angle.

电源电压线包括形成钝角的边缘部分。

3·Power supply voltage selection switch can be used as a supply voltage 110v and 220v.

电源的供电电压可使用转换开关选择110v和220v作为供电电压。

4·Power supply voltage fluctuations must be within the allowable range, and remain relatively stable.

电源电压波动必须在允许范围内，并且保持相对稳定。

5·The power supply voltage may be controlled by replacing D1, D2, R1 and R2 with a variable voltage reference.

将D 1、D 2、R1和R2换成一个可变参考电压源，本电路就变成了一个可控电源。

6·The voltage conversion circuit generates a first voltage and a second voltage based on a power supply voltage.

电压转换电路基于电源电压产生第一电压和第二电压。

7·The filament current and X-ray power supply voltage are checked before the exposure signal can be transmitted.

在曝光信号发出之前，灯丝电流和X线管电压都要被检查核对。

8·It depends on the tube type, the power supply voltage, the reflected impedance, and the required operating point.

这取决于管式，供电电压，反映阻抗，以及所需要的工作点。

9·Therefore, the installation of the machining center location, the need for strict control of power supply voltage.

因此，安装加工中心的位置，需要电源电压有严格控制。

10·To pay attention to access the power supply voltage frequency and whether air compressor configuration consistent.

要注意接入电源的电压频率是否和空压机配置一致。