全部

1·Some ways to get the solubility parameter proposed in this paper.

提供了溶解度参数的几种获取方法。

2·The solubility parameter is usually determined at room temperature.

通常溶度参数是在室温下测定的。

3·The result was consistent with the result of solubility parameter method.

这一结果与溶解度参数法判定结果相当一致。

4·The compatibility forecast of polymer blend systems can be performed by the solubility parameter or the mixing enthalpy.

聚合物形成共混体系的相容性的预测能够通过聚合物间溶度参数或混合焓变来实现。

5·Solubility parameter and results showed that there was no corrasive phenomenon between the polyethylene strand and the coating.

用溶解度参数原则来评价涂料与网绳的涂装，结果表明，本试验研制的防污涂料对聚乙烯网绳无溶蚀作用。

6·The selection principal of low toxic mixed solvent of CR adhesive is depended upon hydrogen bond index and solubility parameter of the solvent.

氯丁胶粘剂的低毒混合溶剂的选择原则是：根据溶剂的氢键指数及溶解度参数。

7·The cloudiness method and the intrinsic viscosity method were used for determining the solubility parameter and its three dimensional components.

用浊度法估测该聚合物的溶度参数，并用特性粘度法对其溶度参数分量进行了订定。

8·The solubility parameter of methyl vinylsilicone rubber(MVQ) was determined with the equilibrium swelling method and the viscosity method respectively.

采用平衡溶胀法和粘度法分别测定了甲基乙烯基硅橡胶（MVQ）的溶解度参数。

9·The effects of the content of solvent and the solubility parameter of solvent on the conductivity of the carbon filled conductive composites are discussed.

进而讨论了溶剂的含量、溶解度参数、混合溶剂挥发速率对碳系填充型导电高分子聚合物导电性能的影响。

10·Then, chose acetone, ethyl acetate, xylene and dimethylformamide according to solubility parameter close principle as solvents to dissolve coating finishing agents.

然后利用相似相溶原理选择了四种有机溶剂进行剥离实验：丙酮、二甲苯、二甲基甲酰胺及乙酸乙酯。