全部

1·The direct steam curing after the unloading of hot pressing CPB could greatly accelerate thc hydration of cement.

板坯卸出压机后的直接蒸养可大大加速水泥的水化过程。

2·The dry shrinkage rate of standard curing concrete sand mortar evidently exceeded the steam curing simples at the same age.

标养水泥砂浆的干缩率明显大于同龄期蒸养水泥砂浆试件。

3·This article gives an integral introduction of intelligent steam curing system, and analyses in details its features and maintenance during operation.

本文通过对智能蒸养系统工艺的整体介绍，详细地分析了智能蒸养系统的特点及在工作中的维护。

4·The orthogonal test, using industrial process residues-fly ash to replace partial cement in order to develop the steam curing fly ash concrete, is made.

本文通过正交试验，以工业废渣—粉煤灰代替部分水泥研制蒸养粉煤灰砼。

5·The steam curing condition has no effect on the variety of the hydration products but on their amount and improves pozzolanic activity of mineral admixtures.

蒸汽养护条件并没有对各种水化产物，但其量，并改善矿物掺合料的火山灰活性。

6·Because the facture need condition of steam curing and compressing, the complicated technology, rigid operation and relatively high costs, so the application is limited.

由于大都采用了蒸压或蒸养的制作方法，生产工艺较复杂、操作过程要求较严格，产品的生产成本相对较高，在推广应用方面受到一定影响。

7·On similar projects, with 50m span length (single spans, cantilevering 1/5), the cycle time is usually approx. 10 - 12 days without steam curing, reinforced in-situ by hand.

类似项目50米跨（单线，1/5悬臂）没有使用蒸汽养生和预制钢筋笼，一个工作循环为10-12天。

8·Mixed efficient jianshuiji USES steam curing of concrete, concrete should have the necessary structure strength to warming, steaming raise system should be determined by test.

掺高效减水剂的混凝土采用蒸汽养护时，混凝土应具有必要的结构强度才能升温，蒸养制度应通过试验确定。

9·The experimental results indicate that steam curing condition increases early hydration velocity of cement-fly ash composite binders and improves compressive strength of hardened pastes.

试验结果表明：蒸汽养护条件提高了水泥-粉煤灰复合胶凝材料的早期水化速度，并且提高了硬化浆体抗压强度。

10·The application of steam curing process for precast segmental beams of Humin Elevated Project has increased the early strength of concrete and met the requirements of construction progress.

沪闵高架工程预制节段梁采用蒸汽养护的工艺，使混凝土早期强度增长，满足了施工进度要求。