全部

1·Plugs which have good grips capable of maintaining a firm hold on the cable sheath should be selected.

有好夹子能维护牢固举行在缆绳鞘的插座应该被选择。

2·The glue surface shall be smooth and clean. The glue surface height may be 5-10mm lower to the cable sheath.

灌注后的胶面应整洁明亮，胶面高度可低于电缆护套5 ~ 10毫米。

3·And optical fiber is made of insulating material, will not arise the problem of waveform distortion caused by the radiation of the charged cable sheath.

而且光纤非由绝缘体资料造败，出无会呈现同轴电缆果外皮带电引行辐射招致波形得实的题纲。

4·Based on the investigation of development state of the cable sheath fault location devices home and abroad, a new cable sheath fault testing device is designed in this thesis.

本文在对国内外电力电缆护层测距仪的现状进行分析的基础上，设计了一种新型的电力电缆护层故障测试仪。

5·This paper shows the methods for determining the ideal Shielding factor of cable sheath, and gives the formulas for calculating the additional impedance due to magnetic flux in the steel armor.

本文介绍了缆皮理想屏蔽系数的确定方法，同时给出了由钢带内的磁通引起附加阻抗的计算公式。

6·If controlling inappropriate in checkout of power cable outer sheath thickness, then will increase difficulty in operating and production cost.

对电力电缆外护套厚度的检验若控制不当，就会增加操作难度和产品成本。

7·Intrinsic safety type control cable with PE insulation, PVC sheath, Individual and General shielding.

聚乙烯绝缘，聚氯乙烯护套，分屏蔽和总屏蔽本安型控制电缆。

8·Intrinsic safety type control cable with flame resistance PVC insulation, PVC sheath, Individual and General shielding.

阻燃聚氯乙烯绝缘，聚氯乙烯护套，分屏蔽和总屏蔽本安型控制电缆。

9·Note: cable approx weight is PVC sheath cable weight.

注电缆近似重量为聚氯乙烯护套电缆重量。

10·Hardy cable production PUR polyether every day of the sheath control cable, water resistance, oil resistance, resistance to abrasion, ripstop.

耐寒电缆天天生产PUR聚醚类外护套控制电缆，抗水解，耐油，耐磨，抗撕裂。