全部

1·When flange thickness and total height adopt standard values, these two parts of marks may be omitted.

当法兰厚度及法兰总高度均采用标准值时，此两部分标记可省略。

2·All expansion joints shall have bolted flange-to-flange type connections on both sides of expansion joint for removal of complete unit. Minimum flange thickness shall be 6 mm.

所有的伸缩接头(膨胀节)都应当采用法兰栓接。法兰的最小厚度为6毫米。

3·Subsequently, draw some regularity result and give suggested thickness and length of flange connecting plate in actual engineering.

得出了一些规律性的认识，给出了建议的翼缘连接板长度和厚度设计值。

4·The simulated thickness with separation force is smaller than that with blank-holder gap because the BHF is variable in the flange region.

采用分离力时的模拟厚度比压边间隙小是由于法兰区域的变压边力。

5·The support flanges are formed by pinching the blank during the hydroforming process to provide a double thickness flange.

在液压成形工艺期间，通过挤压坯料形成支撑凸缘，以提供双厚度凸缘。

6·Then multiple factor analysis of OSC, including the thickness of outer shell, flange plate and web plate of T-shaped members, with or without ribbed stiffeners, is carried out.

采用有限元模型对外套管式节点进行包括外套管厚度、T型件翼缘厚度、T型件腹板厚度以及有无加劲肋的多因素分析，分析总结了这些因素对节点性能的影响。

7·In order to ensure the limit capacity of stiffener, it is suggested to choose thickness of stiffener as the same as beam flange.

在工程中为保证肋板对集中力荷载的承载力要求，建议肋板厚度取一倍于梁翼缘厚度。