全部

1·No deformation martensite phase was discovered.

没有发现形变诱发马氏体相。

2·The interface of austenite and martensite is somewhat straight.

奥氏体和马氏体之间的界面为较平直的界面。

3·The structure of the two system is mainly the twin-type martensite.

两种制度的组织均为主要是孪晶型马氏体。

4·The microstructure of surfacing metal is lath martensite and carbide.

堆焊层显微组织为低碳马氏体和碳化物。

5·Fine structure of martensite in M-A constituents is twin sub structure.

组元中马氏体的精细结构为孪晶亚结构。

6·Mainly its metallographic structure consists of acicular ferrite and martensite.

钢的组织主要由针状铁素体和马氏体两相组成。

7·They are dislocated lath martensite area and twinned martensite area respectively.

这些微区分别为内孪晶马氏体区和位错板条马氏体区。

8·The structure of the studied steels was bainite, martensite and retained austenite.

研究用钢的室温组织为贝氏体、马氏体、少量残余奥氏体。

9·This equation reflects the special character of martensite phase transformation well.

该方程能较好地反映马氏体相变特征。

10·These lath martensite first nucleates in parent austenite intergranular and twin boundary.

应变诱发马氏体首先在原奥氏体晶界和孪晶界形核。

马氏体

1·Tempering is possible because of the instability of the martensite, the principal constituent of hardened steel.

由于马氏体这一淬硬钢主要成分的不稳定性，使得回火成为可能。

2·Retained austenite reduction and carbide precipitations in the martensite are anticipated by the tempering process.

减少残余奥氏体和马氏体碳化物的降水预计的回火工艺。

3·The final structure obtained from tempering a fully hardened steel is called tempered martensite.

回火完全淬硬钢得到的最终组织结构被称为回火马氏体。

4·The decomposition and transformation of the retained austenite in bainite differ from that in martensite.

贝氏体中的残余奥氏体分解和转变的行为与马氏体中的不同。

5·The research describes the formation of Widmanstatten structure and martensite in iron-carbon alloys possessing a broad range of carbon contents and heat treated using a broad range of cooling rates.

该项研究描述了铁碳合金中魏氏组织和马氏体的形成，所用合金具有宽的碳含量范围，热处理时采用的冷却速率范围也是宽的。

(1)martensite steel马登斯体钢

(1)tempered martensite回火马氏体