全部

1·The magnetic induction intensity at meniscus was about 10% of that maximum value at mould middle section.

钢液弯月面处的磁感应强度是结晶器中心最大值的10%左右。

2·The relationship between current density and magnetic induction intensity in the damping passage is obtained.

得到电流密度与阻尼器通道处磁感应强度之间的关系。

3·Magnetic induction intensity, magnetic flux, Gauss theorem of magnetic field, Biot-Savar law, magnetic field of moved charge.

磁感应强度，磁通量，磁场的高斯定理。毕？萨定律，运动电荷产生的磁场。

4·The running currents have been established by controlling the magnetic induction intensity nearby the meniscus when protection casting.

通过控制保护浇注时弯月面附近的磁感应强度来确定工作电流。

5·The equation shows that the magnetic induction intensity is a sinusoidal oscillation signal and its amplitude is a damped exponential law.

公式表明，电磁成形时磁感应强度正弦震荡，幅值呈指数规律衰减。

6·A coil measurement system has been designed to measure the magnetic induction intensity of the weak magnetic field generated by hypervelocity impact.

为了测量超高速碰撞过程中产生瞬态弱磁场的磁感应强度，设计了弱磁场测量的线圈系统。

7·The magnetic induction intensity at the center of elliptic current ring is derived based on the Biot-Savart law and elliptic parameter equation intensity.

运用毕奥萨伐尔定律和椭圆参数方程，计算出椭圆环电流中心的磁感强度。

8·The magnetic induction intensity distribution B is obtained by solving its magnetic vector potential A distribution of current-carrying circular circuit in anisotropic medium.

提出一种求解各向异性磁介质中电流磁场的新方法，通过求解各向异性磁介质中圆电流环的磁矢势A分布，求出其磁感应强度B分布。

9·The magnetic induction intensity of fluid gap was measured without MR fluid in the damper. The nicety of magnetic FEM method was verified by comparing the results of FEM method and experiment.

通过试验，测量了该阻尼器在未装入流体的情况下流体通道间隙处的磁感应强度大小，并与有限元分析结果进行比较，结果验证了磁场有限元分析的准确性。

10·The study has developed a kind of small-sized roller test unit of high magnetic induction intensity for magnetic separation by the technology of permanent magnetism and high magnetic field intensity.

本项研究采用永磁强磁场技术研制出了具有高磁感应强度的小型磁分离试验装置。