全部

1·The output will pass through a transient phase and set down to a steady state response that will be of the same form as, or bounded by, the input.

输出经过瞬态阶段后将回到与输入有相同形式的稳态或者是在输入的附近。

2·The output will pass through a transient phase and settle down to a steady-state response that will be of the same form as, or bounded by, the input...

输出会通过一个过渡的阶段然后稳定于一个稳态反应，其形态和输入相同或者受输入的约束。

3·A detecting method for the phase drift in excited signals based on wavelet packet analysis is presented. This method can detect the transient phase drift in signals at great level.

提出了一种基于小波包分析的激磁信号相位漂移检测方法，能够以较高的精度检测出相位信号的瞬时漂移。

4·In the first, the general situations of research about transient phase transformation used by both ordinary and special shock tubes, including some experimental condition controls, are introduced.

首先介绍利用激波管研究水汽瞬态相变的概况，并介绍一些特殊激波管及实验状态的控制。

5·Its benefits is to reduce the phase delay, thus reducing the phase distortion speaker, improved transient response of the speaker.

其好处是减少了的相位延时，从而减低了扬声器的相位失真，改良了扬声器的瞬态响应。

6·Phase competitive nucleation in the alloy was discussed by classical nucleation theory and transient nucleation theory.

利用经典形核理论与瞬态形核理论计算讨论偏晶合金的两相竞争形核规律。

7·Based on the water-oil phase flow theory, the paper has established the mathematics model of water-oil phase transient well test analysis containing water influence.

基于油水两相渗流理论，建立了考虑含水影响的油水两相不稳定渗流试井分析的数学模型。

8·The reliability and transient stability of the transmission system may be improved, because two adjacent phase conductors of four-phase transmission lines can be operable.

四相线路可以采用两相邻相运行，能提高输电系统运行的可靠性与暂态稳定性。

9·An circular radial shearing interferometer based on spatial phase modulation is proposed to measure the transient near infrared laser pulse wavefront with high precision.

提出了一种基于空间相位调制技术可用于近红外瞬态波前高精度检测的环形径向剪切干涉仪。

10·In this method the transient fault signals are analyzed with wavelets transform to obtain the transient fault information, and the fault circuit is selected by the synthetic phase comparison method.

该方法利用小波变换分析所采集的故障暂态信号，提取用于选线的暂态信息，并采用综合相位比较法确定故障线路。