全部

1·The armature circuit may be fed from either an amplifier or a contactor. The direction and speed of armature rotation depend on the value and polarity of the armature voltage.

线圈环路可以连接到放大器或者电流接触器上，线圈转动的方向和速度的大小取决于线圈电压的记性和数值大小。

2·Then the model is applied to simulate the direct start-up process, the reduced voltage starting process and the starting process with series resistance in the armature circuit.

据此仿真模型，进行了并励直流电动机的直接起动、降压起动、电枢回路串电阻起动的实例仿真实验，给出了有关仿真结果。

3·The field circuit and the armature circuit can be interconnected in various ways to provide a wide variety of performance characteristics - an outstanding advantage of DC machines.

励磁绕组和电枢电路有各种接法，因而有不同的性能，这是直流电动机的显著优点。

4·The control to welding procedure is realized by a control circuit, and wire feed rate is regulated and controlled by speed governing circuit with the armature voltage negative feedback.

由控制电路实现焊接程序的控制，带电枢电压负反馈的调速电路控制和调节送丝速度。

5·Introduced the repair-experience of the AC driver of the electrostatic printer and proposed the method to improve the primary circuit with the solid-state armature.

介绍静电复印机AC驱动器的维修经验并提出用固态继电器对原电路进行改进的方法。

6·There is however a gap in the magnetic circuit between the pole piece and armature so a force is created which ACTS to close this gap and complete the magnetic circuit.

然而在磁回路的电机片和电枢之间有一个间隙，于是产生一个力，其作用是关闭这个间隙以完成这个磁回路。

7·The apparatus and meters can be used to check it, as to the defect of failing to check directly, such as stator armature, the short circuit of silicon steel slice.

对于不能直观检查的缺陷（如定子铁芯、硅钢片短路现象），需要借助仪器、仪表检测。

8·The utility model relates to an electromagnet, which is composed of a yoke iron, an armature iron, a push rod, a pull rod, a starting coil, a sustain coil, a controlling circuit and an end cover.

本实用新型涉及一种电磁铁，有轭铁、衔铁、推杆、拉杆、启动线圈、维持线圈、控制电路和端盖。

9·A short circuit device is arranged on an armature winding of electric power generation of the fan-driven generator.

本实用新型在风力发电机的发电电枢绕组上装有短路装置。

10·Armature manufacture and design of 6-layers-serials printed circuit motor is introduced here.

介绍了六层印制绕组电机电枢的设计与的制作。