全部

1·The zero reading may also vary as the ambient temperature changes. This effect is usually referred to as the temperature coefficient of the voltage offset.

仪器的零点读数也会随着环境温度的变化而变化。这种效应通常称为电压偏置温度系数。

2·Although the average was zero, each interval had a maximum (and a minimum) reading. In this graph, my APM is displaying a flat zero line indicating the average but also the maximum value.

虽然平均值是零，但是每一个时间间隔都有一个最大(和最小)读数。

3·You do so via the seek method, which takes a single parameter that indicates where in the file you want to start reading or writing (for example, zero indicates the start of the file).

回到开头要通过seek方法进行，它接受一个参数，表示要从文件中的什么位置开始读取或写入(例如，0代表文件开头)。

4·Finally, after each sampling and cleaning sequence the measurements’ zero point ischecked with a water freeness measurement to make sure the next reading isrepeatable.

最后，在完成每次取样和净化顺序后，必须借助于水游离度测量来校正测量仪器的零点，以确保可以进行下一个读数。

5·In other cases, it can either be subtracted from the reading by using the REL (zero) feature or simply canceled out by using built-in zero suppression if the instrument has this feature.

在另一些情况下，则可以使用REL(零点)功能将其从读数中减去，或者简单地使用内置的零点抑制功能(如果仪器具有此功能的话)将其消除。

6·An easy way to do this is to enable the REL function after zero check is disabled, which nulls out the charge reading caused by the hop.

为做到这一点，简单的做法是，在零点检查关闭之后打开REL功能，这样就能把零跳的读数消除掉。

7·Every word wrong, so fast reading speed until enough speed, but on the quality of the zero.

到处写错单词，做快速阅读，速度始够速度了，但质量就等于零了。

8·This count can match the expected number of items or be less (even zero) due to a matching failure, a reading error, or the reach of the end-of-file.

这个数可以匹配项目的预期数量或是少(甚至为零)由于匹配失败，读取错误，或文件结束达到。

9·Reading of 85 degrees below zero are common in both the Arctic and Antarctica.

是在北极在南极，华氏零下85度是很常见的。

10·Just before the voltage source is turned on, disable the meter's zero check and suppress the charge reading by using the REL function to zero the display.

在电压源即将打开之前，关闭仪器的零点检查功能并使用REL功能抑制电荷读数，使显示为零。