全部

1·Note that the relatively large cathode current of the TL431CLP requires correspondingly small values of R7 and R8.

注意到TL431CLP产生较大的阴极电流需要相应阻值较小的R7和R8。

2·You must take this difference in the magnitude of the cathode current into account when selecting values for R7 and R8.

在选择R7 和R8的阻值时，你必须考虑这两种不同大小的阴极电流的区别。

3·Using beam emission models, the influence to the magnetron characteristics by the cathode current destiny can be obtained.

利用磁路电子注发射方式针对不同的阴极发射电流进行了动态模拟，得到了不同发射电流条件下磁控管的工作特性。

4·The estimation of the cathode current density of CRTs from cathode image by means of TV camera and micro-processing technique is proposed.

本工作利用电视和微处理技术，把整幅阴极象存入微机内存，经处理后推算出阴极电流密度。

5·Electrolytic process is an important method of producing copper powder, two important parameters of which are particle size of copper powder and efficiency of cathode current.

电解法是制备铜粉的一种重要方法，铜粉的粒径和阴极的电流效率是其两个重要的指标。

6·By running an electrical current through the cell, using an ordinary battery charger, the copper in the anode (and in the pins) dissolves and is deposited on the lead cathode.

要想让电流通过电解池，你需要一个普通的电池充电器。阳极和针脚里的铜溶解之后会聚集在阴极上。

7·Electrolysis: make the current through the electrolyte solution at the anode and cathode cause REDOX reaction process.

电解：使电流通过电解质溶液而在阳极，阴极引起氧化还原反应的过程。

8·It and reversing current different is not to be, but with a anode intermittently stop, because the intermittent power supply current interrupted, cathode potential with time periodically change.

它与换向电流所不同的是不把镀件作阳极，而是间歇地停止供电，由于间歇中断电流，阴极电位随时间周期性地变化。

9·Along with the increase of the current density, cathode polarization effect, coating grain with increasing more and fine.

随着电流密度的增加﹐阴极极化作用随着增加﹐镀层晶粒越来越细。

10·Cathode temperature is one of the most important factors influencing the stability of high current glow discharge.

阴极的温度是影响大电流辉光放电稳定工作的重要因素。