全部

1·Using this method in landslide correction, the sliding resistance of soil can be increased.

应用此方法，并与膨胀锚相配合，进行滑坡治理，可以增加坡面土体的抗滑能力。

2·The results indicate that the sliding resistance is greatly reduced by the lubrication effect of a thin film plaster on the soil surface.

结果表明：田面有泥浆薄层时船体滑行阻力将大大降低。

3·The resistance coefficients presented in this paper can be used as the reference to predict the sliding resistance of floating boat under similar conditions.

文中列出的阻力系数值可供预测同类条件下的船拖船体滑行阻力时参考。

4·From the model, the landslide thrust and remanent sliding resistance behind the piles can be calculated with the limit equilibrium theory and coefficient of transmission method.

利用极限平衡理论，采用传递系数法，系统地给出了滑坡推力和桩前剩余抗滑力的计算方法。

5·Sliding resistance was replaced by the fixed value resistance, and potentiometer was used to adjust volt, it could make measurement of diode reverse characteristic more convenient.

用定值电阻代替滑线变阻器，用分压器调节电压，可使二极管反向特性的测量更加方便。

6·This is so because the resistance to motion is essentially due to the deformation of the rolling elements and, hence, is not a sliding phenomenon.

之所以这样是因为对运动的阻力基本上源于滚动零件的变形，而不是滑动现象。

7·Loose hole plating chromic layer by weight used in the sliding friction parts and heat resistance, corrosion, wear parts, such as internal combustion engine cylinder lumen, piston rings.

松孔镀铬层应用于受重压的滑动摩擦件及耐热、抗蚀、耐磨零件，如内燃机汽缸内腔、活塞环等。

8·It is a balance system that the anti-slide pile is exerted by three kinds of force, they are the tensile force of anchor, the thrust of sliding mass, the resistance of soil and rock.

一般认为锚杆（索）抗滑桩在锚杆（索）拉力、滑坡推力、桩前滑体抗力的作用下绕锚固点（锚拉力作用点）保持力矩平衡，锚固点为一铰支点。

9·Shifting your mental focus to feeling what your hands naturally do at the front of your stroke, can make you aware of the difference between sliding through the water, or creating resistance.

将你的思想焦点感觉你的双手做在游泳的时候。你通过水让你自己意识到滑动的差异，或创造的阻力。

10·The experiment results show that under service loads the slabs 'strength, rigidity, resistance to cracking and sliding are all meet the code requirements.

试验结果表明：在设计荷载下板的强度、刚度、抗裂度及迭合面抗剪性能均能满足规范要求。