全部

1·An inward stroke, especially a piston stroke moving away from the crankshaft.

内冲程向内的冲程，尤指从曲轴移回的。

2·The size of the steel tube is lengthened by the following needed size in comparison with the piston stroke.

钢管尺寸比活塞行程加长以下需用尺寸。

3·The result show that the piston area and the accumulator volume have more influence on the system 's performance, and the piston stroke...

结果表明，活塞面积和蓄能器体积对系统性能影响比较大，而活塞最大行程和油液弹性模量对系统性能影响较小。

4·Reciprocating pump flow and pressure head has nothing to do with the pump cylinder size, and the reciprocating frequency of the piston stroke.

往复泵的流量与压头无关，与泵缸尺寸、活塞冲程及往复次数有关。

5·This paper by use of perturbation method found asymptotic periodic solution of piston stroke, and found rational periodic for periodic external force.

本文用摄动方法求得了活塞行程的渐近周期解，且为周期性外力求出合理的周期。

6·The authors consider that increasing the piston stroke is an effective scheme, and point out that the petaloid combustion chamber has a good adaptability.

作者认为，加长行程是十分有效的方案，同时也指出花瓣形燃烧室具有良好的适应性。

7·Piston stroke length of 1, as well as the piston per minute species reciprocating cylinder liner at the number (referred to as red pump or pump a few) n-related.

活塞行程长度1，以及活塞每分种在缸套种往复的次数n有关。

8·Reciprocating pumps convert rotary motion to linear motion. Pump speed in RPM determines the pumps output volume for any given combination of cylinder bore and piston stroke.

循环泵将曲轴旋转运动转化为柱塞的直线运动。泵速转每分钟决定了任何气缸和活塞组合的排泵量。

9·Therefore, the design method of double elbow clamping mechanism and piston stroke is proposed, which is in favour of working steady and reliability of injection moulding machine.

进而提出利于注塑机工作平稳的双肘锁模机构和活塞行程的设计方法。

10·A two-stroke engine has no moving valves, and the spark plug fires each time the piston hits the top of its cycle.

二冲程发动机没有移动的阀，火花塞每次点火活塞到达循环顶端。