全部

1·Coil resistance is determined by the cross-sectional area and length of the wire used in winding the coil.

线圈电阻是由线圈导线的横截面积和长度决定的。

2·The effects of coil resistance and the number of turns to operating mechanism closing time and moving velocity of the iron core are simulated and analyzed.

通过改变线圈电阻和匝数两个参数，分别仿真分析了线圈电阻和匝数的改变对于操作机构合闸时间及动铁芯运动速度的影响。

3·The resistance of the primary coil has been neglected.

忽略原边线圈电阻的条件下推导出来的。

4·It was reported that the overvoltage level of low resistance grounding mode is lower than that of arc suppressing coil mode, but the operation carried out the other way.

但经多年的运行，各地普遍认为小电阻接地方式比消弧线圈接地方式的过电压水平要低，但同时反映出的运行状况却存在较大差异。

5·The Rogowski coil ranged in the same axis was used as current sensor, in which the self-integral resistance should has smaller inductance and smaller capacitance as possible.

电流测量探头采用自积分的罗柯夫斯基线圈，自积分电阻的电感、电容要尽可能的小，并采用同轴结构。

6·The check is in the series of coil and four-way reversing valve control relay contact resistance increases, the bad, the contacts the voltage reduced.

经查是与四通阀线圈串联的控制继电器触点接触不良，电阻增大，致使电压降低。

7·Theoretical computation and analysis is carried out to find the relationship between the resistance and induction of the coil and its size.

对线圈的电阻、电感和线圈的尺寸等关系进行了理论计算与分析。

8·In addition, coil watts and contact resistance are reduced.

另外，卷瓦特和联络抵抗被减少。

9·This paper has briefly discussed the factors that influence the performance of coil coatings film, such as t bend, MEK resistance and adhesion, etc.

简述了影响卷材涂料T弯、耐mek性、附着力、铅笔硬度、耐沾污性等性能的因素。

10·Then it introduces the rotor earth fault monitoring based on the method of resistance bridge with source, and the interturn short circuit fault monitoring in generator rotor based on stator coil.

随后介绍采用基于有源电阻电桥进行转子接地短路故障监测与采用微分探测法进行转子匝间短路故障信号。