全部

1·The lack of bonding was existed in the case of lower deformation rate.

当变形率较小时界面有未焊合存在。

2·The melting point of eutectic decreases slightly with the increase of deformation rate.

共晶熔化开始温度随形变率的增大略有下降。

3·The temperature and the deformation rate are the key factors to prepare ultra-fine grain materials.

变形温度和变形速率是获得超细晶材料的关键。

4·It is considered that the carbon gradient of carburized layer can be controlled by hot-rolling deformation rate.

分析认为，可以用热轧形变量大小控制渗碳层的碳梯度。

5·The influence of rainfall and excavation on slope displacement is proven immediately by increasing slope deformation rate.

同时监测结果表明，降雨和开挖使边坡位移速率显著增大。

6·Rolled molybdenum plate has a high density, even close to its theoretic value when the deformation rate is higher than 50%.

经过轧制的钨板具有很高的密度，变形率达到50%以上的钨板的密度基本上接近理论密度。

7·The re-crystallization rule of SWRH82B steel at high-temperature, more rolling times and high deformation rate was studied.

研究了SWRH82B钢在高温多道次高变形速率下再结晶的规律。

8·It is shown from the study that different hierarchy levels correspond to different strength, viscosity and deformation rate.

由研究可以看出，不同的构造层次对应着不同的强度、粘性及应变率。

9·The Shanxi graben zone has the largest fault deformation rate showing it is the most important block boundary of North China.

山西断陷带的断层形变速率最高，是华北地区最重要的活动块体边界；

10·If the cold deformation rate is higher than 70 %, the recrystallized grain size distribution agrees with lognormal distribution.

在冷形变量大于或等于70 %时，其再结晶晶粒尺寸分布符合对数正态分布。

变形率

1·Excellent resistance to oil, high temperature resistance, weather resistance are good, but the mechanical strength, compression deformation rate and water resistance is slightly worse.

对油品有极佳的抵抗力，耐高温、耐候性均佳，但机械强度、压缩变形率及耐水性稍差。