全部

1·Attach test leads to pins 1 and 2 and note ohmmeter reading.

把测试探针连接到插头1和2，并记下欧姆表读数。

2·Attach test leads to pins 5 and 6 and note ohmmeter reading.

把测试探针连接到插头5和6，并记下欧姆表读数。

3·The test current is forced through the test leads and the resistance (R) being measured.

我们迫使测试电流流过测试引线和被测电阻（R）。

4·Complete with CAT IV test leads, 9v battery, Type K probe, pouch case, and Professional test lead Set.

完成CAT IV测试信息，9v电池，K型探头，眼袋情况，以及专业测试引线。

5·But many cancer specialists say that if the test leads to more screening, that is not necessarily a good thing.

但很多癌症专家称如果这项测试导致更多的检查，它不见得就是件好事。

6·Shielding the test leads and the DUT (Figure 3-6) will often reduce interference effects to an acceptable level.

对测试引线和DUT进行屏蔽(图3 - 6)常常能够将这种干扰的影响降低到可以接受的水平。

7·The meter then measures the voltage across the resistance through the same set of test leads and computes the resistance value accordingly.

然后仪表通过同一套测试引线来测量电阻两端的电压，并计算出相应的电阻数值。

8·The ability to store test leads without first detaching them and access them easily by means of a sliding cover reduce setup and cleanup time.

无需首先分离主机和测试棒方便存放，而可轻松打开滑盖直接使用，既减少程序又节约时间。

9·Measurements made using the micro-ohmmeter are always performed using the four-wire technique in order to minimize errors caused by test leads and connections.

使用微欧计进行电阻测量必须采取四线技术以使测试电缆和连接器带来的误差减至最小。

10·This is especially important when higher currents are used because the voltage drop across the test leads may be large compared to the voltage drop across the contact.

在使用较大的电流时，这一点特别重要。因为和接点两端的电压降相比，测试引线两端的电压降可能会比较大。