全部

1·The fabrication procedure of the mask and results of the deep X ray lithography are given.

给出了该掩模设计制作工艺过程及深x射线光刻结果。

2·The fabrication procedure of two kinds of microwave multilayer printed circuit board filled with ceramic particles is briefly introduced.

简单介绍两种陶瓷粉填充微波多层印制板的制造工艺流程。

3·Some corresponding control methods were proposed through the quality analyses in the total fabrication procedure of the blower horizontal air coolers.

通过对鼓风水平式空气冷却器制造全过程中出现的质量问题进行分析，并提出相应的控制措施。

4·The paper introduces the welding procedure and fabrication process of titanium alloy wheel, indicates the inspection method and quality result of welding location.

介绍了钛制叶轮的焊接工艺和制造过程，说明了焊接部位的检查方法及检查结果。

5·This procedure describes in detail the overall fabrication process, which starts from preparation of steel plates to rolling, welding, inspection etc.

本程序详细描述了整个建造过程，包括板材准备到卷制、焊接、检验等。

6·In this paper, the fabrication of intermediate joint, selection of crimping tool, construction procedure and difficult point in technique are introduced in detail.

本文详细介绍了中间接头的制作，压接工具的选择，以及其施工方法与技术难点。

7·With that mask, an improved procedure on fabrication of phase type CGH is also presented.

利用掩模板，本文同时展示了一种加工位相型CGH的新工艺流程。

8·During its fabrication process, bonding is the key procedure to almost all microfluidic chips.

在微流控芯片的制造过程中，键合是关键步骤之一。

9·This article introduced the establishment of welding procedure of tube -tube sheet welding, and the fabrication of equipment.

本文介绍了管子管板封口焊幻焊接工艺制定及产品的焊接。

10·This article introduced the establishment of welding procedure of tube - tube sheet welding, and the fabrication of equipment.

本文介绍了管子管板封口焊的焊接工艺制定及产品的焊接。