全部

1·The emphasis of the study is Maximum Power Point Tracker based on quadratic interpolation.

重点研究了二次插值法的最大功率点跟踪技术。

2·This paper describes also quadratic interpolation and the method of transformation of coordinates used in the calculation.

计算中所运用的二次插值及座标变换方法，在文中作了介绍。

3·One method is phase difference correction of partly FFT; the other is FFT frequency correction with quadratic interpolation.

一是利用分段FFT的相位差修正算法，二是基于二次内插的频率FF T校正法。

4·By analyzing the partial linearization algorithm of CTDM, a quadratic interpolation method is proposed to obtain the approximated optimal step size.

对求解CTDM的部分线性化算法进行分析，提出了在进行步长优化时使用二次插值法得到模拟最优步长的方法。

5·Analysis and computation of reactively loaded directive arrays is done by using the method of Moments (MOM) and an optimization procedure based on a quadratic interpolation method.

本文利用矩量法和基于二次插值法的优化方法对电抗加载定向天线阵进行了分析计算。

6·A modified segmental quadratic interpolation method which describes the shape of optical system pupil with relative coordinate error less than 1% and area error about 0.25%, is presented.

本文提出了一种改进的分段二次插值法描写光学系统的光瞳形状，得到了满意的效果，其坐标误差小于1%，面积误差约0.25%。

7·You can choose a linear interpolation or quadratic, but you've got to choose it.

你可以选择线性插值或抛物线型插值,但你总要做出选择。

8·The quadratic monotone interpolation characteristic difference method is proposed to overcome these defects.

为克服其不足，建立和研究了二次单调插值特征差分方法。

9·A backtracking interpolation theory based on the synthetic interpolation theory was expounded, a controlling program used to cutting straight line and quadratic curve has been developed successfully.

论述了基于曲线合成插补理论的反向合成插补理论，研制出直线和二次曲线切割加工控制程序。

10·Based on analysis of quadratic spline interpolation, the shortest quadratic spline interpolation is discussed. Furthermore, golden section method is put forward to solve this problem.

在分析了样条函数插值基础上，提出最短二次样条插值问题，并提出用黄金分割法解决该问题。