全部

1·The effect of shear deformation and rotary inertia are considered in the paper.

文中考虑了剪切变形和转动惯量的影响。

2·Servo motor has a long overload ability, have smaller rotary inertia and big plugging around moment.

伺服电机有较长的过载能力，有较小的转动惯量和大的堵转转矩。

3·Notes:Weight and rotary inertia are approximate value calculated by the greatest shaft-hole dia. of Y type hole.

注：重量、转动惯量是按最大轴孔直径Y型孔计算的近似值。

4·It is also shown that the influence of the rotary inertia of the mass block on the shear failure is not negligible.

质量块的转动惯量对于剪切失效具有不可忽略的影响。

5·The result also denotes rotary inertia and the shear formation of the beam have significant effect on the high frequencies.

考虑梁的剪切变形和转动惯量时，对梁的高阶频率影响较大。

6·The result also denotes the shearing deformation and rotary inertia of the beam have significant effect on the high frequency.

当考虑梁的剪切变形和转动惯量时，则对梁的高阶频率影响较大。

7·To study the influence of rotary inertia on gear flowmeter natural frequency, keep damping and leakage coefficient as constant.

结果表明：与增大泄漏系数、阻尼系数相比，减小转动惯量可以明显的提高流量计的频率响应。

8·But when the rotary inertia of the hub is close to that of the beam, the zeroth-order approximation model may lead to wrong result.

但当中心刚体的转动惯量接近柔性悬臂梁的转动惯量时，零次近似模型将导致错误的结果。

9·The natural frequencies of the intelligent beam with the rotary inertia and shear deformation of the beam are lower than that without those.

考虑梁的转动惯量和剪切变形时，智能阶梯梁的频率比没有考虑时的要低。

10·The vibration and noise of the pump. 7 because the rotary inertia force component inside the pump is low, can work under high rotation speed.

⑥泵的振动和噪声极小。 ⑦因为泵内的回转部件惯性力较低，可在高转速下工作。