全部

1·Themaxium range of allowable stress under different reliability is given.

文中还给出了对应于不同可靠度下的最大容许应力幅值。

2·Strength Design values may be converted to Allowable Stress Design values.

设计要求、强度设计值可转换为许用应力设计值。

3·Some datum, for example safety factor and allowable stress are put forward based on production practice.

提出的设计数据如安全系数、许用应力均根据生产实践的应用所确定。

4·In this case allowable stress of imported material shall be those for equivalent material in GB150-1998 as follows.

在此情况下，进口材料的允许应力与GB150 - 1998中的相当材料相同。

5·The allowable stress is the value of the determined basic allowable stress of the piping material multiplied by a quality factor.

而管道许用应力是在确定了管道材料的基本许用应力后，乘以质量系数所得的值。

6·The allowable stress levels to which the actual stress levels are compared are based on empirical findings for the material involved.

对所使用的材料来说，与实际应力比较的容许应力是以实验研究结果为基础的。

7·The allowable stress of the pipe material shall be chosen from the data of GB 50316 Design Specification for Industrial Metal Piping.

管子材料的许用应力可按GB 50316《工业金属管道设计规范》中的数据选用。

8·At last, under the allowable stress with ANSYS to optimize the design of the final model and gain a new kind of horn with resonance of 12.35.

最后借助ANSYS优化设计模块进行仿真实验，在材料许用应力下对变幅杆进行优化设计，获得了谐振比达12.35的新型变幅杆。

9·If the above link is greater than the allowable stress, it will lead to destructive damage, or even crack, collapse and other serious consequences.

以上环节中若出现大于允许应力时，就会导致破坏性损伤，甚至折裂、坍塌等严重后果。

10·The many indefinite exists in the design parameters and influence factors of the working stress and allowable stress of the roller movable teeth drive.

滚子活齿传动设计中，在工作应力、许用应力的设计参数和影响因素中存在着许多不确定性。