全部

1·A passive sampling technique with electric collecting for measurements of radon flux rate is described.

本文描述了测量氡析出率的驻极体收集被动采样法。

2·The effects of activate carbon, in-flux rate and adsorbent on the quality and yield of product were studied.

研究了活性炭种类、上样速率、 吸附剂种类及其浓度等条件对产品质量和收率的影响。

3·Under high flux or flux rate radiation, the efficiency of formation of some radiation defects reduce obviously.

在大辐照注量和注量率下，某些辐照缺陷形成率将明显降低。

4·Flocculation and moderately increasing the temperature will enhance the ultrafiltration flux rate of glucoamylase broth.

对糖化酶发酵液进行絮凝处理及适当提高温度都有利于超滤速度的提高。

5·The detection result of the relative energy flux rate distribution in the medium can correspond to the theoretical result very well.

用所制作的光纤探头探测散射介质中的相对能流率分布所得的实验结果与理论结果相符合。

6·We found that the flux rate of fluorescence in tissue is the function of the depth on the assumption that tissue is semi infinite media.

首先模拟分析半无限大介质模型中的荧光，认为最终逸出组织表面的荧光在组织中的产率是深度的函数；

7·The nano-indentation results show through changing the deposited voltage and C_2H_2 gas flux rate could increase the hardness and elastic modulus of the films.

纳米压痕试验结果表明，通过改变沉积负偏压和C_2H_2流量可以提高薄膜的硬度和弹性模量。

8·The results show that the major influence factors of the cutting quality for thick titanium and its alloy plate are water pressure, sand flux rate and cutting rate.

结果表明，水压、沙流量和切割速率是影响钛及钛合金中厚板切割质量的主要因素；

9·Based on concentration polarization-gel layer mathematical model, effects of various factors on ultrafiltration flux rate of glucoamylase solution have been studied.

以浓差极化-凝胶层数学模型为基础，研究了影响糖化酶超滤速度的各种因素。

10·The ultrafilter should be sized to provide 3.0 gallons per minute of ultrafiltrate for each 100 ft. 2 /minute of coatable surface area even when flux rate is at low level.

但超滤装置的规格必须大一些，即使在低的渗透量时也可为每100平方英尺/分得涂装面积供应3.0加仑/分的超滤液。

流量

1·Although most parameters design of the machine are confirmed by analogy methods presently, a flux rate and strength theories are the restriction conditions that they should satisfied.

虽然目前双螺杆磨浆机设计的大部分参数需要采用类比法确定，但流量和强度条件是其应当满足的约束条件。

2·The results show that the major influence factors of the cutting quality for thick titanium and its alloy plate are water pressure, sand flux rate and cutting rate.

结果表明，水压、沙流量和切割速率是影响钛及钛合金中厚板切割质量的主要因素；