全部

1·Here, the heat flow rate and the vapor temperature were estimated on a ready-made commercial heat pipe.

对成品热管测定了传热量和管内蒸气温度。

2·Some heat release rate formulas are added to the application software for calculation on the properties of the fire smoke flow in building.

将各种非稳态火源热释放速率计算式嵌入建筑物火灾烟流性状预测软件并进行了算例验证。

3·The rate of heat flow between any two points increases with difference of temperature.

任何两点间的热流动速率则随温差的加大而增加。

4·But gas flow rate is too big, but will make arc beam are short and heat loss increased ability to cut down to make cutting process, cannot proceed.

但气体流量过大，反而会使弧柱变短，损失热量增加，使切割能力减弱，直至使切割过程不能正常进行。

5·T he flow rate regulation range was too narrow, and the change of heat removing capacity depended on the change of inlet temperature.

揭示了液体流率受管道结构等条件的限制，合理调节范围较窄，服装温度比效率不会很高，应主要靠调节进口液温来改变服装的散热量。

6·When we measure the heat capacity of heat pump by enthalpy measuring method, we use flow rate measuring method to measure flow rate and sectional mean temperature of air.

利用空气焓值测量方法对热泵的制热量进行测量时，通常采用测流量法测量空气的流量和截面平均温度。

7·When we measure the air heat capacity of heat pump by enthalpy potential method, the flow rate measuring method was used to measure flow rate and sectional mean temperature of air.

利用空气焓差法进行热泵空气侧换热量测量时，通常采用测流量法测量风的流量和截面平均温度。

8·Through a test research for heat pipe radiators of steel column type, we get the relative formula of heat transfer rate, calculating temperature difference and flow rate of the heat medium.

通过对钢制柱型热管散热器的试验研究，得出了散热器热流量和计算温差、热媒流量的关系式，并提出了进行热工性能试验的方法及进一步研究的意见。

9·The effects of system parameters such as system pressure, mass flow rate, heat flux and inlet sub-cooling are significant on both DWO and PWO.

系统压力、质量流速、热负荷和进口过冷度等参数对不稳定性有显著的影响。

10·Besides, the influence of air feeding efficiency and gas flow deflection etc to the heat recovery rate of honeycomb are discussed.

另外还讨论了供风效率和气体偏流等其它因素对蜂窝体热回收率的影响。