全部

1·The velocity of the gas affected on the discharge process a little.

烟气流动速度的增加对放电特性的影响很小。

2·The prepulse phenomena in the discharge process of accelerator are analyzed in this paper.

分析了脉冲线加速器在放电过程中产生的预脉冲电压现象。

3·The electro-pulse discharge process was verified by a set of pin-plane-pin electrode device.

通过“针—板—针”电极放电实验证实了上述串联脉冲放电过程。

4·The specific capacitance of composites shows no obvious fading after 30 times in the charge-discharge process.

在充放电30次以后，材料的放电比电容基本不再发生变化，趋于稳定。

5·Interlinked with the exhaust port volume of the space c, is gradually reduced, and is in the discharge process.

而与排气口相通的空间c的容积是逐渐缩小的，正处于排气过程。

6·On the testing equipment, air discharge process can be accomplished via hand control and automatic control manners.

利用该实验装置分别以手动控制模拟器和自动控制装置控制模拟器完成了空气放电过程。

7·Thus it can predicate the discharge process of basin outlet of the different rainfall combinations of the sub-basin.

可以预测不同子流域降雨组合下的流域出口的流量过程。

8·The fluidizing characteristics and powder discharge process of gas fluid bed reactor with Hypol process were described.

介绍了聚丙烯流化床反应器流化特性和卸料过程；

9·Through analysis, an actual discharge process line method should be adopted to calculate calculating average discharge per diem.

经分析采用了实测流量过程线法推算日平均流量，推算成果满足《规范》规定的精度要求。

10·Fluid model was used to analyze the discharge process and the discharge efficiency of the driving pulse with different wave shapes.

本文采用流体模型， 分析了多种驱动电压波形下，PDP的放电过程和放电效率。为选择合适的外加驱动电压提供帮助。