全部

1·Small grease dirt and powder use a mild detergent or solvent cleaning, then rinse and dry; or scrub with a damp cloth to completely remove all stains.

细小油脂污物及粉未使用中性清洁剂或溶剂清洗，再用清水洗净，干燥；或用湿布擦洗，以彻底清除所有污迹。

2·Oil, grease and other contaminants shall be removed from the steel and adjacent polyethylene surfaces by solvent cleaning in accordance with SSPC SP1 prior to abrasive blast cleaning.

根据SSPC SP1的规定，在喷砂处理之前，应当用溶剂将附着在钢材及相邻聚乙烯材料表面的油脂及其他污染物清洗掉。

3·Oils, greases, fats products and others oily contaminants shall be totally removed by means solvent cleaning or by means of an industrial biodegradable detergent, followed by water rinsing.

油剂、润脂油、脂肪产品等油类沾染物应该用溶剂清洗或用工业用生物降解洗涤剂清洗，然后用水冲洗干净。

4·Warning: Make sure to check that compressed air and power supply are disconnected before cleaning. If not, disconnect them. Organic solvent shall not be used to clean the machine.

警告：在清洗之前必须检查压缩空气和电源是否关闭。如果没有关闭，请关闭压缩空气和电源。严禁使用有机溶剂清洗机器。

5·Cleaning by water and solvent.

水，溶剂清洗两用。

6·After blasting or surface treatment chemically and cleaning by solvent, the metal insert was plated FR1, predried, then adhered by thermal cure, a good effect was gained.

金属骨架经喷砂或表面化学处理并用溶剂清洗之后，涂FR 1型粘合剂，经预烘干后与橡胶进行热硫化粘着，效果良好。

7·Bench Cans provide an easy means of cleaning small parts in solvent.

台式罐为在溶剂中清洗小部件提供了简易的方法。

8·The firm did not have adequate controls over these solvent drums, did not do adequate testing of drummed solvents, and did not have validated cleaning procedures for the drums.

公司没有对这些溶剂桶进行适当的控制，而且没有对桶中的溶剂进行适当的测试，也没有对桶的清洗过程进行验证。

9·Chemical resistance: resistant to cleaning agents and weak solvents, such as oil solvent oil.

耐化学性：耐清洁剂及弱溶剂，如石油溶剂油。

10·As diluent in paints and varnishes industries; solvent for metal cleaning and degreasing; textile printing solvent and dry cleaning solvents.

作为油漆及清漆制造用之稀释溶剂；金属清洗及脱脂用之溶剂；纺织印花用溶剂及可作衣物干洗用溶剂。