全部

1·The results show that response frequency of gear mechanism will be reduced by gear backlash and multi-frequency phenomenon will occur.

计算结果表明，齿侧间隙的存在会降低机构的响应频率，并会产生多频现象。

2·After the proper backlash is achieved, perform Gear Contact Pattern Analysis procedure.

在达到合适的齿隙后，执行齿轮接触印痕图形分析过程。

3·For increased accuracy and repeatability, the unit can be supplied with an external anti-backlash POM (polymer) pinion gear which optimizes coupling to the wind turbine's large yaw bull gear.

为了提高其准确度和重复性，该装置被附带一个外部的反侧隙聚甲醛(聚合物)小齿轮，该齿轮可优化风力涡轮机的大偏航从动齿轮。

4·In this paper, the accuracy influences of general gear ratio, transmission error and driving backlash on servo system were analyzed, and some measures of gear ratio distribution were presented.

文章分析了伺服系统中精密齿轮传动装置总传动比、传动误差、传动回差对整个系统的精度影响，提出传动装置各级精度分配时应注意的问题。

5·There are many influential factors for backlash of the gear pair. This paper studied various factors and discussed the calculating methods and steps on backlash of the gear pair.

本文在分析各种影响齿轮副侧隙因素的基础上，讨论齿轮副侧隙的计算方法和步骤。

6·After getting the formula about the normal backlash and the stiffness of the tooth pairs of the gear, the contact ratio and the load correction factor could be obtained.

在获得齿轮内啮合传动的齿侧间隙计算公式以后，结合齿对刚度的计算公式，推导出齿轮内啮合传动的加载重合度及载荷修正系数。

7·After the proper backlash is achieved, perform the Gear Contact Analysis procedure.

在得到合适的齿隙后，执行齿轮接触分析程序。

8·A dynamic analysis model in which the gear error and the time-varying stiffness and backlash are included is established for a 2-stage star gear train.

建立了两级星型齿轮传动系统的非线性动力学分析模型，模型中考虑了系统的综合啮合误差、时变啮合刚度以及齿侧间隙。

9·In this paper, the simulate curve and result for the backlash Center Adjustable Gear train in various cases are given by the random simulate method.

利用随机模拟方法给出了可调中心距齿轮链空程在各种情况下的模拟曲线及计算结果。

10·On the campaign servo motor through a pair of circular tooth pulleys, belts, one pair of anti-backlash gear and ball screw deceleration drive;

工作台运动由伺服电机通过两个圆弧齿形皮带轮，和圆弧齿形皮带降速传动。