全部

1·Maximum deformation and residual deformation are given by solving the systems of simultaneous equations.

通过求解建立的平衡方程组，给出了平台的最大变形和残余变形。

2·Based on the test results, the mechanism of the influences of reinforcement on the residual deformation is proposed tentatively.

还根据试验结果，初步探讨了加筋对动残余变形影响的机理。

3·The foundation stability and residual deformation must be evaluated before building life or service facilities above old mine goaf.

在老采空区上方建设生活或服务设施时，必须对老采空区上方地基稳定性和残余变形情况进行评价和预测。

4·A method of energy difference between elastic deformation and elastic-recovery deformation is developed to determine the residual deformation energy.

本文提出用弹性变形能与弹复变形能的差值来确定残留变形能的方法。

5·The article introduces a repair welding technology which prevents the worn axis from residual deformation and assures the repaired axis normally running.

介绍了一种防止磨损轴在焊补过程中出现残余变形，以保证修复轴正常运转的轴磨损无变形焊补工艺。

6·The different trademarks have little influence on wind pressure resistance of aluminum-plastic composite plate and have great influence on residual deformation.

不同铝材牌号对铝塑复合板的抗风压性能影响不大，但是对其残余变形的影响较大。

7·The results showed that if 5% steel bars are substituted by carbon fiber bars, the residual deformation and maximum curvature decrease compared with the reinforced concrete pier.

分析结果表明，如将普通纵筋的5%改配为碳纤维筋，在强地震荷载作用下桥墩残余位移以及最大曲率响应均小于普通钢筋混凝土桥墩。

8·The results show that: with the initial principal stress direction angle increases, the axial residual deformation from the compression state gradually transits to the elongation.

结果表明：随着初始主应力方向角的增大，轴向残余变形由压缩状态的正值逐渐过渡到伸长状态的负值。

9·The rear impact roller stretches the weld longitudinally with transverse compressive plastic deformation of the weld, thus reducing the residual deformation and stresses in the bead.

后轮将焊缝金属的纵、横向压缩塑性变形充分碾展，减小了工件的残余变形和应力。

10·In unloading process the direction of friction will convert to prevent restoration of shear deformation between the fissures, which results in the residual deformation in the specimen.

卸载时摩擦力的作用方向会发生改变，并抑制裂隙面之间滑移变形的恢复，使岩样内部产生残余变形。