全部

1·There is a fracture process zone near the crack tip for the tensile strain softening materials.

在应变软化材料的主裂缝尖端存在一断裂过渡区。

2·In the eastern area, the tensile strain is very intensive, while the compressive strain is very weak.

东区存在非常强烈的张应变，压应变则很弱。

3·The results show that the theoretical and experimental critical surfaces of the maximum tensile strain are very close.

结果表明，按最大拉应变理论所得到的理论临界曲面和试验临界曲面相当接近。

4·To break down the eutectic carbide network of A-cast structure with grain size 4-5 grade, tensile strain of 60% is needed.

当铸志晶粒度力4 ~ 5级寸，破碎晶炭化物组织需要有60%以上的拉应变。

5·The effect of tensile strain on electrical resistance of continuous carbon fiber monofilament was investigated in this paper.

研究了连续碳纤维单丝的应变电阻效应，分析了在拉应力作用下其电阻率的变化规律。

6·At the same tensile strain, the power law relationship between band propagating velocity and applied strain rate is also obtained.

得到了在相同应变下，变形带的传播速率和加载应变速率之间的幂律关系。

7·When the tensile strain reaches the limit load, the force of tension suddenly becomes very small, because clusters structures change.

当拉伸应变达到承载极限，继续拉伸，力突然变的很小，这是因为团簇发生了结构变化。

8·The hot tensile strain process of the microstructure of duplex stainless steel was investigated with high temperature microscope (CSLM).

本文利用共聚焦激光扫描高温显微镜(CSLM)等设备对双相不锈钢的高温拉伸微观变形过程进行了研究。

9·The measurement of tensile strain distribution of optical fiber is very necessary to guarantee the long-term reliability of optical cable.

通信光缆拉伸应变分布测量对于保证光纤通信线路的长期可靠性具有十分重要的意义。

10·According to the curve, the spall strength, the thickness of spall scab and the tensile strain rate under different condition were obtained.

根据所得曲线波形计算出相应条件下的层裂强度、层裂片厚度以及各自的应变率，最后得到层裂强度随拉伸应变率变化的关系曲线。