全部

1·Reboots phone to reset mode.

重新启动手机重置模式。

2·If another pacemaker is used, it should have a bipolar pacing reset mode and be programmed for bipolar pacing to minimize the possibility of the output pulses being detected by the device.

如果患者使用有其他起搏器，则该起搏器应具有一个双极起搏重置模式并针对双极起搏进行程控，以使其输出脉冲被脉冲发生器检测到的可能性降至最小。

3·The suid and sgid bits are set and reset symbolically using the letter s; for example, u+s sets the suid access mode, and g-s removes the sgid mode.

suid 和 sgid 位使用字母 s 在符号上进行设置和重设；例如，u+s 设置 suid 访问模式，g-s 删除 sgid 模式。

4·This low-level area of the hardware allows you to reset a hung system, boot from a specific device (like a CD or a network boot), or get into single-user mode.

硬件的这个低级区域允许您从特定的设备（如 CD 或网络）启动重新设置挂起的系统，或允许您进入单用户模式。

5·In this mode, the TX signal will be HIGH during reset or idle.

在这种模式下，TX信号为高电平期间将重置或空闲。

6·The buttons are Set, Reset, and Back to View mode; the text controls are to accept the Link name and the URL of the link.

按钮是 Set、Reset 和 Back to View mode；文本控件用于接受链接名称和链接的 URL。

7·Reset will clear all registers, wake up from idle mode keep registers unchanged.

复位将会清零所有寄存器，从空闲模式被唤醒将保持寄存器的内容。

8·Imprinting is not possible while the data back is being reset. When resetting is complete, press the mode button until the imprint mark appears on the display panel.

当日期背盖正在重新设定时，将不可能影印，完成重新设定后，请按压模式按钮直到显示屏上出现影印符号。

9·The Power-down mode saves the register contents but freezes the Oscillator, disabling all other chip functions until the next Interrupt or Hard- ware Reset.

掉电模式时晶体振荡器停止振荡，所有功能除了中断和硬件复位之外都停止工作；

10·Relative rotation of the two-part housing resets the lock cylinder via the reset member and detent pin, and allows the lock cylinder to be placed in a learn mode for rekeying without a valid key.

两部分壳体的相对旋转通过复位构件和定位销来复位锁芯，并且允许锁芯处于记忆模式，用以在不需要有效钥匙的情况下更换钥匙。