全部

1·The main wiring uses the single generatrix emanant wiring plan.

主接线采用单母线放射式接线方案。

2·The temperature in generatrix layer is higher than in the worm wheel layer.

母线层的温度较高，而蜗壳层的温度较低。

3·We need to consider the deformation of only one strip parallel to generatrix of the cylinder.

我们只需要考虑一个平行于圆柱母线的窄条的变形。

4·The key point for re-constructing rotation surface is setting up rotation axis and generatrix.

旋转面重建的关键是确定旋转轴和母线。

5·A conic section whose plane is not parallel to the axis base or generatrix of the intersected cone.

圆锥的一部分，其切面既不平行于轴和基面，也不平行于圆锥母线。

6·There are mainly four parts in the new type data collection system: generatrix signal collection device;

本文设计的新型数据采集系统主要包括四个部分：母线信号采集装置；

7·Straight generatrix shape roller and arc generatrix shape roller are incompletely the same in processing.

形母线与圆弧形母线滚子，在采用无心贯穿磨削时，并不完全相同。

8·A novel supersonic induction heating supply is researched, which is suitable for large-area generatrix brazing.

对高频感应加热电源中的线圈进行了研究与设计。

9·Because most firebox generatrix is composed of complex curves, it is very difficult to get CNC cutting program with manual means.

由于燃烧室外表面的母线轮廓复杂，手工编制数控加工程序难度大。

10·According to the restriction of the generatrix line Bertrand surface can be constructed with the Bertrand curve with broad sense group.

按照母线的约束，形成广义白川德曲线族，进而构造出白川德曲面。

母线

1·Taking the straight-line-rack as the tool the error of straight generatrix is measured and by error analysis the tooth profile error and tooth orientation error can be obtained.

以刃边齿条为工具，测量廓面的直母线族误差，通过误差处理与分析获得齿廓总偏差和螺旋线总偏差。

2·According to the restriction of the generatrix line Bertrand surface can be constructed with the Bertrand curve with broad sense group.

按照母线的约束，形成广义白川德曲线族，进而构造出白川德曲面。

3·The key point for re-constructing rotation surface is setting up rotation axis and generatrix.

旋转面重建的关键是确定旋转轴和母线。

4·Formula to evaluate translation of the tooth-surface and the equation to describe the generatrix of the negatively cambered sooth-surface were derived respectively.

分别推导得到齿面平移距离和内凹齿面母线方程的计算公式。

5·We need to consider the deformation of only one strip parallel to generatrix of the cylinder.

我们只需要考虑一个平行于圆柱母线的窄条的变形。