全部

1·In terms of the feature of radius compensation for coordinate measurement, the natures of offset curve and surface are studied in the dissertation.

根据坐标测量需进行测头半径补偿的特点，研究了正则等距曲线曲面的有关性质。

2·The algorithm proposed by us for polygonal chains intersection based on the sweep line algorithm is extended, and it is used to detect and delete global self-intersections in the rough offset curve.

拓展了我们已有的平面上单调链求交的扫描线算法，将其应用到初步等距线中的全局自交点和全局无效环的确定上。

3·Beam curve offset: the amount of height offset to apply to the projected beam to generate a smoother curve even when the beam is pointing straight.

(光束曲线偏移)：投射光束时应用的高度偏移量，就算在光束径直指向时也能产生一个光滑的曲线。

4·The client environment is modeled after the Web browser concept, with many familiar controls to help offset the learning curve of the virtual world experience.

客户机环境按照 Web 浏览器概念建模，许多控制方式是大家熟悉的，这有助于用户快速地掌握虚拟世界。

5·Also, computer simulation is conducted to work out the contrast curve of scanning spots and the offset voltage across the modulation unit of the optical phased array.

最后通过计算机模拟计算，得出扫描点的对比度曲线以及相控阵调制单元上所加的补偿电压。

6·Static correction problem is resolved by adopted methods like sand dune curve, interactive refraction static correction, and offset-division surface-consistent residual static correction.

采用沙丘曲线法、交互折射静校正法以及分偏移距地表一致性剩余静校正等技术，较好地解决了静校正问题。

7·The characteristic of quick-return of offset double crank slider mechanism was analyzed in this paper. The synthesis method and curve of this mechanism with minimum transmission angle were presented.

本文分析偏置双曲柄滑块机构的急回运动特性，给出了按最小传动角设计偏置双曲柄滑块机构的设计方法和设计曲线。

8·Consequently, with the use of curve fitting method, the inversion of all seismic lithologic parameters can be easy achieved, and zero-offset section can be obtained.

所以利用曲线拟合方法很容易实现全部地震岩性参数的反演，并可提取零偏移距剖面。

9·The paper introduces the concept of curve following turnout branch line, the confirmation of head and end, the chord offset calculation of points, the measuring steps in the field.

文章介绍了道岔附带曲线的概念及头尾的确定，各各点支距的计算和现场测设步骤，并确定了拨道整正方法。

10·The stress beyond which stainless steel undergoes important permanent flow — commonly specified as that stress producing a 0.2% offset from the linear portion of the stress-strain curve.

Yield Strength 屈服强度 不锈钢在恒流下的受到的压力-通常被定为使压力应变曲线线性产生0.2%偏移量的压力。