全部

1·The resonance method excited by sine sweeping and the transfer function method excited by hammer impact are adopted.

试验分别采用正弦激励模态共振法和锤击激励传递函数测量法。

2·The contactless electrostatic resonance method to determine the cross sectional area of conductive and unconductive monofilament was introduced.

介绍了一种可测试所有导电和非导电纤维横截面积的非接触式静电共振法。

3·The local projective noise reduction and demodulated resonance method for fault diagnosis of low speed rolling bearing are presented in this paper.

本文将局部投影降噪算法结合共振解调技术对低频轴承进行故障诊断。

4·The double resonance method for the measurement of small capacitance is presented. The effects of the distribution capacitance can be greatly reduced.

提出一种两次谐振的小电容测试方法，它能有效地抑制分布电容的影响。

5·The dispersion and standing wave factor are measured by resonance method. Compared with the theoretical results and simulating results, they match very well.

采用谐振法测量它们的色散特性和驻波系数，实验结果与理论计算值和模拟值吻合良好。

6·The dispersion characteristics of the shielded planar transmission lines are analyzed by the transverse resonance method combining with variational technique.

本文利用横向谐振法结合变分技术分析了屏蔽平面传输线的色散特性。

7·Based on the parameter calculation of the air core reactor, this paper presents a pulse voltage resonance method to detect turn to turn insulation defects in air core reactors.

在对干式空心电抗器参数计算的基础上，提出了用脉冲电压谐振法进行电抗器匝间绝缘缺陷的检测。

8·The temperature spectra and frequency spectra of the damping capacity in the IM and RS/PM Al-Li alloys with the same composition were measured by the resonance method with the plate specimens.

采用板片状试样的共振法，测定了同一成分的铸锭合金（IM）和快速凝固粉末冶金（RS／PM）铝锂合金的阻尼温度谱和频率谱。

9·A formulation for the equivalent circuit parameters of the discontinuities with superior convergency is derived by the transverse resonance method with the singular integral equation technique.

利用横向谐振法结合奇异积分方程技术，导出了具有快速收敛特性的不连续性等效电路参量计算公式。

10·In order to solve the problem, the reasons for the leakage are analyzed in the paper, and the gas-water resonance method is adopted to wash the generator stator coil. Good results have been achieved.

针对该问题，分析了泄漏的原因，并采用气、水共振法对发电机定子线圈进行冲洗，取得了较好的效果。