全部

1·The dielectric strength test can be made to be destructive or non-destructive.

电气强度测试可分为破坏性和非破坏性。

2·The cord set completed required cycles of flexing with no occurrence of end results and also successfully completed the Dielectric Strength Test without breakdown.

插头完成了要求的弯曲周期，没有出现上文所提到的最后结果，并且通过了电绝缘强度测试，没有损坏。

3·The Dielectric Strength Test is to be performed between each pair of conductors (including ground if applicable) and between each conductor and the foil wrapped cord guard.

电介质强度试验是在每对导体（包括地）之间和每个导体与包装了金属薄片的尾档之间测量。

4·By analyzing the case of the dielectric strength test on household top-heating automatic soymilk machine, this paper briefly discuss two questions which should be pay attention to during safety test.

从结构设计和元器件选用两方面分析了上加热式家用全自动豆浆机在抗电强度试验时遇到的问题，并就安规测试中需要注意的问题进行了论述。

5·Test result of dielectric strength, partial discharge and endurance property are analyzed and contrasted between solid dielectric is two film and tree film in model capacitor elements.

本文比对分析了极间介质为两层膜和三层膜的模型电容器元件的介电强度、局部放电性能以及耐久性能的试验结果。

6·This paper briefly introduces the requirements about the insulation system of electronic product, and describes the importance of functional check and Dielectric strength in safety test.

本文简述电子电气产品对绝缘系统的要求，以及在产品的安全测试中抗电强度试验和对测试仪器作运行检查的重要性。

7·Standard Test Method for dielectric breakdown voltage and dielectric strength of D149 ASTM solid electrical insulating materials at industrial power frequencies.

ASTM D149固体电绝缘材料在工业电源频率下的介电击穿电压和介电强度的试验方法。

8·Test method for ASTM D149 solid electrical insulating materials at commercial power frequencies the dielectric breakdown voltage and dielectric strength.

ASTM D149固体电绝缘材料在工业电源频率下的介电击穿电压和介电强度的试验方法。

9·This paper introduces a new type of test circuit for measuring the ar (?) gap dielectric recovery strength of low voltage electrical apparatus.

本文介绍一种测量低压电器弧隙介质恢复强度的试验线路。

10·In chapter 5, the essence of the commutation's dielectric strength detecting is one of screening test of reliability.

第五章基于可靠性相关理论，揭示了换向器片间介电强度检测的实质，即其本身是一项可靠性筛选试验。