全部

1·The control device (30) controls the voltage-up converter (12) using a feedback voltage control value.

控制设备(30)使用反馈电压控制值来控制升压转换器(12)。

2·It has the welding current feedback circuit and the welding voltage feedback circuit.

具有焊接电流反馈控制电路及焊接电压反馈控制电路。

3·Repetitive control is used to reduce voltage distortion under nonlinear loads and instantaneous feedback control is designed to quicken the dynamic response process under abrupt load variation.

系统利用重复控制抑制非线性负载下的电压畸变，利用瞬时值反馈控制加快负载突变时的动态响应过程。

4·The control system utilizes a sliding mode observer for the generation of all controller feedback information by means of non-speed information, such as voltage, current and parameters of motor.

利用非速度信息，如：电机的电压、电流及电机本身参数，通过滑模观测器产生控制器所需的速度反馈信息。

5·Cut off power supply check signal the feedback loop is switched on, the voltage is normal or not.

切断电源检查信号反馈回路是否接通，电压是否正常。

6·Adopt IGBT frequency conversion of German Siemens and voltage feedback series resonance circuit. The conversion efficiency is reaching up to above 97.5%.

采用德国西门子IGBT变频，电压反馈串联谐振电路。变换效率高达97.5%以上。

7·The effects and problems of using active voltage feedback method to suppress the RAM are researched.

研究了利用主动电压反馈抑制剩余幅度调制的实际效果和存在问题。

8·In this paper, quantitative analyses on the effects of driving signal with different bias voltage polarity are made for double-sided driving with voltage feedback.

文章中定量分析了带有电压反馈的双边驱动信号对器件特性的影响。

9·This feedback being connected downstream Q1 transistor, the general behavior of this voltage supply is very sensitive to sensor impedance variation.

这个反馈被连接到下游的三极管Q1，此电源电压的特性，对阻抗的变化很敏感。

10·The low-voltage power line channel properties are analyzed in this paper and a decision feedback channel estimation method is proposed on condition of slow time-variant of channel.

该文分析了低压电力线信道特性，利用信道慢时变的特点提出一种适合于电力线信道的判决反馈信道估计方法。