全部

1·With horizontal trimming die, horizontal trimming pro- cess can be fulfilled.

使用水平切边模具，可以完成轮辐的水平切边加工。

2·Analyzed the pressing process of the shell part, introduced the structure design points of drawing-trimming die.

对壳体的冲压工艺进行了分析，介绍了拉伸、切边模具结构设计的要点。

3·Adjacent to the table is the third unit which contains a belt conveyor, a grid trimming die and another belt conveyor.

与工作台相邻的第三个装置，包括传送带，板栅修边用模具和第二条传送带。

4·The key points in designing a two operating position punching and trimming die for shaping an automotive little leaf spring were discussed.

介绍了某车型片簧冲大孔、切边双工位模具设计要点及注意事项。

5·The service life of M16 hexagon trimming dies was extended remarkably by means of analyzing the exerted force and optimizing the materials of die.

通过模具受力分析、材料优化等措施，显著提高了M16六角切边模的使用寿命。

6·The work process of the trimming die for vertically forming the thin-wall barrels of the shell top part of hot-water shower device was introduced.

汽车覆盖件中，存在着大量的翻边特征，而翻边零件的修边线直接影响到修边模的设计和翻边后零件的质量。

7·The work process of the trimming die for vertically forming the thin-wall barrels of the shell top part of hot-water shower device was introduced.

分析了轴盖的冲压工艺性，对传统工艺进行了改进，介绍了其复合模和修边模结构及设计要点。

8·The work process of the trimming die for vertically forming the thin-wall barrels of the shell top part of hot-water shower device was introduced.

介绍了热水器外壳顶盖类薄壁筒体件垂直成形修边模及其工作过程，模具调试时出现的问题及解决方案。

9·Through the technological analysis of the trimming process for the isobutylene-isoprene rubber plugs, the structure of the trimming die has been determined.

通过对丁基橡胶瓶塞切边工艺分析，确定了丁基橡胶瓶塞的切边模具结构。

10·To reduce the cost and lead time of developing a trimming die, a method to obtain the trimming line in flange process is proposed on the basis of blank grid deformation.

为减少修边模的开发周期和成本，提出一种基于板料网格变形的修边线确定方法。