全部

1·After emerging from the lamp reflector, the p-polarized light would pass through a half-wave retarder that would occupy half of the beam cross section.

反射后的p偏振光将通过一个半波纠正器，将占用一半的光束截面。

2·Continuing along its path, this portion of s-polarized light would be reflected twice by the lamp reflector, and would finally be reflected perpendicularly, by the beam splitter, toward the LCD panel.

继续沿其路径，这部分的s偏振光将灯泡反光罩反射两次，最终由偏振分光镜得到垂直反射到液晶面板。

3·The final reflector contour generally sweeps around the lamp and crosses the vertical line through the lamp axis.

最终反射器轮廓一般会掠过灯具周围并通过灯具轴线横穿过垂直线。

4·Other options include using a hot pack an electric heat pad set on its lowest setting or a radiant heat lamp with a 250 watt reflector heat bulb to warm specific muscles and joints.

其他选项包括使用热敷电热垫定于它的最低设置或辐射热灯与25 0瓦的热反射灯泡以热烈的具体肌肉和关节。

5·This paper introduces a high-temperature resistant and low shrinkage unsaturated polyester molding compound used for a novel reflector of automobile lamp.

研究了一种满足新型汽车车灯反射器的使用要求的低收缩率的耐高温不饱和聚酯模塑料。

6·It features a parabolic reflector that rotates around an incandescent lamp, providing 60 flashes per minute in all directions.

采用抛物面反射器，围绕白炽灯旋转，每分钟60次闪光，闪光全面。

7·Because part of moister air in the lamp flows very slow and temperature of part of lamp cover and reflector is low, the fog forms on the lamp cover and reflector easily.

本文从热分析的角度，研究了由于车灯内部局部湿空气流动缓慢以及车灯配光镜和反射镜部分区域温度较低引起的结雾问题，分析了各种典型车灯中存在雾气问题的形成原因。

8·The unpolarized light from a lamp would be concentrated by a reflector and directed to a polarizing beam splitter.

灯发出的散射光将集中到一个反射面，并指向一偏振分光镜。

9·Flash lamp, bettery box, lambency box, sunshade board, reflector board, lambency umbrella, bracket, lamp-chimney, lamp for outdoor etc.

闪光灯，电箱，柔光箱，遮光板，反光板，柔光伞，支架，灯罩，外拍灯等。

10·The unique design of the double paraboloid reflector, so that the lamp light efficiency increase;

独特的双抛物面设计反光罩，使灯具光效大幅提高；