全部

1·The pneumatic circuit and the PLC-based control system are designed.

设计了气动控制回路和PLC电气控制程序；

2·Finally, the design of an under-actuated manipulator which is driven by pneumatic circuit has been finished.

最后，设计了一个利用气压回路驱动的欠驱动机械手。

3·Finish the pneumatic design of all the functions of hill-drop drill, and produce the pneumatic circuit drawings.

对气动部分的各种功能进行了设计，并绘制出气动回路图。

4·In the design section an under-actuated manipulator which is driven by parallel pneumatic circuit are presented.

在设计部分中则提出了一种利用并联气压回路驱动的欠驱动机械手。

5·Meeting all kinds of working conditions and forms of pneumatic actuators in the machine, a simple and reliable pneumatic circuit is put forward.

针对本机床中气动执行元件的不同工作条件和形式设计了简单可靠的气动回路。

6·In this paper, the expert system using Fuzzy Neural network to detect and diagnose faults is put forward through research on pneumatic circuit of assembly lines.

本文通过对气动生产线回路故障特点的研究，提出模糊神经网络故障诊断专家系统的诊断方法。

7·This article introduces the pneumatic control circuit, its design and characteristic.

本文介绍该自动线的气动控制系统、气动回路设计及其特点。

8·The paper introduced a particular pneumatic control circuit to open and close the boiler lid.

本文介绍了开闭蒸锅盖的一种特殊的气动控制回路。

9·It describes the designing, logic circuit, working principle and adjustment of the pneumatic rubber plate logic control system attached to the horizontal multiple-hollow-chisel mortiser.

详细阐明卧式多头打眼机气动膜片逻辑控制系统的设计，逻辑线路，工作原理及其调试。

10·The design idea and steps of one new type design method for pneumatic sequence circuit are concerned in this paper.

介绍了一种新型的气动程控回路快速设计法的设计思想和步骤。