全部

1·Force sensor design principle of the stress concentration.

测力传感器设计的应力集中原则。

2·Big distortion and stress concentration happened near the tip of crack.

裂纹尖端附近有较大变形，应力集中明显。

3·The stress concentration may be reduced if adopting circular arc transition.

采用圆弧过渡可以降低应力集中现象。

4·The stress concentration caused by the corrosion pit was numerically analyzed.

分析了锈蚀坑存在造成钢筋应力分布变化的规律。

5·The expression for calculating dynamic stress concentration factor is presented.

给出了动应力集中系数的计算表达式。

6·The expressions for calculating the dynamic stress concentration factors are given.

给出了界面处动应力集中系数的表达式。

7·The stress concentration factor of cylinder is much larger than that of other three kinds.

圆柱形颗粒的应力集中在基体达到屈服后要远远高于其他三种颗粒。

8·The Phenomena of stress concentration of tubular T joints are investigated widely in this paper.

本文对T型管状接头的应力集中现象进行了广泛的研究。

9·And the paper shows a reasonable connecting form by comparing stress concentration coefficients.

通过对应力集中系数的比较，提出了较为合理的连接形式。

10·Finite element analysis shows that there are three stress concentration areas inside the bearing.

有限元分析表明，轴承内部存在三个应力集中区域。