全部

1·Switch to a condensation curing compound. These compounds do not use platinum and thus are not affected by any of the above.

换成缩合固化。这些化合物不用铂催化剂，因此不会受到以上因素的影响。

2·The preparing method for the internal curing compound of solution-type concrete is characterized in that the following procedures are applied: 1) preparation of raw materials;

溶液型混凝土内养护剂的制备方法，其特征在于包括以下步骤：1）取料；

3·The results showed that a kind of fast curing novolac for shell process whose softing point is reasonable was easily prepared by compound catalysis.

试验表明，采用复合催化法很容易制备聚合速度快且软化点适宜的壳法用热塑性酚醛树脂。

4·The results showed that a kind of fast curing novolac for shell process whose softing point is reasonable was easily prepared by compound catalysis .

试验表明，采用复合催化法很容易制备聚合速度快且软化点适宜的壳法用热塑性酚醛树脂。

5·The external dimensional design, face venting pattern design, compound formulation design of tire curing bladder as well as the manufacture & use of bladders both at home and abroad are presented.

本文介绍了外胎硫化胶囊外形尺寸设计，表面排气花纹设计，胶料配方设计，加工制造和使用的国外和国内情况。

6·The key of designing the mold for rubber spring and compound rubber spring curing and some problems that need pay attention while assembling were introduced briefly.

简要介绍橡胶弹簧和复合橡胶弹簧硫化模具的设计要点及装配时应注意的问题。 附带说明橡胶弹簧退模时的专用工装。

7·Effect of curing temperature, curing time, resistance to media, kind and volume of the sand-laden fluid, and particle size of proppant on fibre compound sand control system were discussed.

探讨了固化温度、固化时间、耐介质性、携砂液的种类和用量以及支撑剂粒径等对纤维复合防砂体的影响。

8·In this paper some parallel tests are done between cement and HS soft soil stabilizer which is compound of cement and 10% curing agent.

对在水泥中加入10%的固化素，复合而成的HS软土固化剂性能与水泥进行了对比研究。

9·In this paper, the security of low salty dry-cured meat was studied by using low-temperature, compound curing agent, desiccation, vacuum packing and fermenting maturation technology.

采用低温、复合腌制剂、干燥、真空包装、发酵成熟等工艺过程，进行低咸度腌肉制品安全性研究。

10·In order to determine reasonable processing parameters, heating of thermosetting molding compound in the mold and that of heat transfer after curing temperature are analyzed.

本文就模压料在模具中加热过程和达到固化温度以后的传热过程进行定量分析，以确定合理的工艺控制参数。