全部

1·The structure of lubricating grease pump was introduced.

简单介绍了低流量脉动泵的结构特点。

2·Lubricating grease: General grease or heavy water grease used for pump.

润滑脂：普通润滑脂或泵用重水润滑脂。

3·Under the normal condition use general lubricating grease, you had best use heavy water lubricating grease for pump if too much leakage loss.

正常情况下使用普通润滑脂，泄漏过大则最好使用泵用重水润滑脂。

4·In a long time stop, remove the pump and dry the parts and coat rust-proof grease on the processed surface.

长期停止使用时，应拆开水泵，将零件上的水擦干，在加工表面涂上防锈油保管好。

5·In order to realize the transportation of grease without flux pulse in the tube, a low-flux pulse pump was developed.

为了实现润滑脂在管路中输送的无流量脉动，研制了一种低流量脉动泵。

6·Sure to rotate the pump shaft when pouring lubricating grease, in order that the grease can get into packing cavity fully until have grease oozed out from gland.

注入润滑脂时必须旋转泵轴，以使其充分进入填料腔，直到填料压盖端有油脂渗出为止。

7·All grease fittings are installed on top of the pump support plate.

所有润滑脂油嘴均安装在泵支撑板顶部。

8·A lubricating grease suitable to meet the individual requirements for chassis lubricant, bearing lubricant, joint lubricant, water-pump lubricant, and cup grease.

可以满足底盘润滑脂、轴承润滑脂、接头润滑脂、水泵润滑脂和杯脂各项要求的润滑脂。

9·This paper briefly deals with the theory, method and characteristics of the design of a twice pressure grease-gas composite pump.

本文简要介绍“二次压力脂气组合泵”的设计特点，设计理论和方法。

10·Water pipe from the pump to the surface all covered by a layer of yellow grease.

从水泵到水管，表面全部被一层发黄的油渍所覆盖。