全部

1·The example script uses the following command to install MSJ: FAStTMSJ*_install.bin -i silent.

示例脚本使用了下面的命令安装 MSJ： FAStTMSJ*_install.bin -i silent。

2·The installation of this rpm is handled by the install.sh script, which then installs MSJ.

这个 rpm 的安装是通过 install.sh 脚本进行的，然后会安装 MSJ。

3·Configure the paths to disk using MSJ as explained under Configuring paths to disks and load balancing.

按照配置磁盘路径和负载均衡中介绍的方法使用MS J配置磁盘路径。

4·The example USES the 32-bit FAStT MSJ in this installation to avoid potential problems installing the 64-bit version.

本文的示例在这次安装中使用了32位的FAStT MS j来防止在安装64位版本时可能出现的问题。

5·MSJ is used for configuration of the Qlogic adapters, failover, and multipathing, which is described in detail under HBA configuration.

MSJ 用于 Qlogic 适配器、故障恢复和多路径等配置，这将在 HBA 配置 一节中详细进行介绍。

6·To accomplish the installation, you can add a script to the end of the GPFS installation to check whether the node is a storage server and install MSJ.

要安装它，需要在GPFS安装程序的末尾添加一个脚本来检查这个节点是否是一个存储服务器，然后再安装MS J。

7·Once you install GPFS on the storage servers, you might also want to automatically install the FAStT MSJ utility, which can be done in silent (non-interactive) mode.

一旦在存储服务器上安装GPFS之后，您可能还会希望自动安装FAStT MS J工具，这可以以静寂(非交互)模式来完成。

8·Note that because this is a 32-bit version of MSJ, and even though the example uses the silent installation, the code looks for and loads 32-bit versions of some libraries.

注意由于这是一个 32 位版本的 MSJ，因此即使示例使用了静寂安装模式，代码也会查找并加载 32 位版本的库。