全部

1·The resin flow in RTM process for thick section parts was investigated.

针对厚截面构件的RTM工艺过程，研究了三维树脂流动问题。

2·The governing equations of resin flow are presented on the base of Darcy's law.

在达西定律的基础上建立了树脂流动过程控制方程。

3·This paper addresses the resin Transfer Molding (RTM) process. The governing equations of resin flow are presented.

介绍了RTM工艺过程及特点，给出了树脂渗流控制方程。

4·Several formulations related to the resin velocity, resin filling time and resin flow pressure were proposed accurately.

提出了较准确的树脂流动速度、树脂充模时间和树脂流动压力计算方程。

5·When the resin flow in the mold, the screw speed control and filled with resin after the pressure (pressure protection) control.

当树脂在模具内流动时，则控制螺杆的移动速度并在填充树脂后用压力(保压力)进行控制。

6·It has a great impact on mold filling time and resin flow pattern, thus affects the process efficiency and product quality.

它对充模时间和树脂流动方式有重要影响，因而影响到工艺的效率和产品质量。

7·The experiments indicate that the monitoring system can precisely reflect the resin flow front arrival and curing course of resin on the inspecting spot.

实验表明，该监测系统能够准确地反映监测点处树脂流动前锋的到达及其固化过程。

8·In this paper, simulations are carried out with the approach of equivalent permeability, and the resin flow front curve and pressure fields with flow channels are obtained.

本文作者采用等效渗透系数方法模拟边缘效应，得到了其影响下的树脂流动前峰曲线和压力场。

9·SHELLCV can simulate the process of mould-filling in RTM for the 3d complex shape thin parts and predict the resin flow front advancement and the distribution of pressure field at any instant in time.

SHELLCV程序包含三角形壳元和矩形壳元两种单元，可以模拟复杂形状三维薄壁构件的RTM制造工艺注模过程，得到任意时刻的树脂流动前峰曲线、压力场分布。

10·Molded into the melted resin from the gate, into the flow channel module slot part of the composition of the product.

成形品是由流入融化树脂的浇口、导入模槽的流道与产品部份所构成。