全部

1·The connection of bus bar USES soldering mode.

汇流带的连接采用焊接方式。

2·The cable wire lug end is then connected to the bus bar.

而后将电缆线 接线头端部连接到母线上。

3·A bus bar voltage dip during motor starting, shall not exceed 10%.

电动机起动时的母线电压降不得超过10%。

4·Probe may be taken bus bar, is intended to facilitate access to bus stops.

探头可能是摄公交车吧，是为了方便公交车进出站。

5·The bus bar is one of the important components in phased array radar antenna.

汇流条是相控阵雷达天线中的重要组件。

6·It offers a new method to calculate the balance of the vertical enclosed bus bar.

这为垂直布置封闭母线的热平衡计算提供了一种新的算法。

7·Bus Bar's current grade, specification of bus bar, heat stability are as follows.

母线的电流等级，导电排规格，动热稳定性能见下表。

8·The shield is slipped down over the bus bar conduit tube to expose the bus bar end connector.

护罩在母线导管上向下滑动，以露出母线端部连接器。

9·The cover shield is then slipped up to cover the bus bar end connector and attached cable wire.

然后将护罩向上滑动，以盖住母线端部连接器和连接的电缆线。

10·For high quality cutting process, large-area milling machine for cast aluminum bus bar was designed.

为适应高质量的切削加工要求设计铸铝母线专用大面铣床。

(1)busbar system母线系统；汇流排