全部

1·Relief Angle valve.

安全角阀。

2·Relief Angle valve. Pressure or vacuum can be specified.

安全角阀。可指定压力或真空度。

3·By using encrypting Angle valve of steel cylinder, clients must fill gas at designated LPG filling station.

使用该钢瓶加密瓶阀后，只能在我们指定的液化气充装站才能充装。

4·The company mainly produces the products involving PP-R ball valve, angle valve, stop valve, check valve and pipe fittings.

本公司主要生产PP-R球阀、角阀、截止阀、止回阀、管接头等产品。

5·According to structural characteristics of a flapper valve, flapper valves, butterfly valves, ball valves, diaphragm valves, Angle valves, through the valve, three-way valve.

根据结构特点有挡板阀、插板阀、蝶阀、球阀、隔膜阀、角阀、直通阀、三通阀。

6·The results show that at any Angle between axes of inclined swirl control valve and crank shift, flow coefficient and inclined swirl ratio increase gradually with increase of valve opening.

研究结果表明，在任意可变斜轴涡流控制阀轴线与曲轴轴线夹角情况下，流通系数和无因次斜轴涡流比随着阀片开度的增大而逐渐减小。

7·There are three parameters of fuel injection system: response pressure, injection-advanced angle, injection valve bulge high degree, the best match was found by adjusting them.

对于喷油系统参数：喷油压力、静态供油提前角和油嘴凸出高度，三个参数进行调整试验，找到它们的最佳匹配。

8·By means of computered modeling and simulating, the variation of the discrepancy of motor voltage and valve Angle are analyzed when system working at proper or fault condition.

利用计算机建模与仿真的方法，对电动节流阀控制系统正常和异常时电机电压和阀门转角的波动进行了分析。

9·Gate, Globe, Angle and Check Valve Figure Number System.

闸阀，截止阀，角阀和止回阀型号编制体系。

10·With the method of industry design, I analyze and compare the mechanical systems, make out of the best design project, then lay the foundation of gas valve design from the Angle of complement.

这里应用工业设计思想，从系统的角度出发对天然气阀的机械系统进行了分析比较，得出了最佳设计方案，为天然气阀的设计奠定了基础。