全部

1·The aerodynamic field for Venturi oil-burner with a intake swirler is simulated by numerical method.

针对带入口旋流器的新型文丘利调风器流场的数值模拟，提出了一种分析模型和处理方法。

2·The results of experimental study on reacting flow behind a swirler by LDA are presented in this paper.

本文给出了用LDA测量旋流器后火焰流场的试验研究结果。

3·The swirl-flow injection washing water-saving device is formed from swirl-nozzle, swirler and multi-stage injector.

本发明涉及一种旋流引射式洗涤节水器，它是由旋流喷嘴、旋流器和多级引射枪组成。

4·Turbulent reactive flow in a short annular combustor is simulated by changing the number and location of nozzle and swirler in combustor dome.

通过改变燃烧室头部喷嘴、旋流器的数目和位置，对短环形流燃烧室内有较强回流的湍流旋流流动进行了模拟。

5·The blockage of swirler in the wasted water system of flue gas desulfurization (FGD) equipment resulted in the unstable operation problem of system.

针对烟气脱硫装置中废水系统旋流器堵塞，致使系统不能稳定运行的问题进行了分析。

6·Meanwhile, the experiment is conducted and the air pressure inside the swirler and the influence of the swirler′s structure upon yarn hairiness are analyzed.

介绍旋流器的结构以及在环锭纺细纱机上的安装位置，实验并分析旋流器中的空气压力以及旋流器的结构对纱线毛羽的影响。

7·A new high temperature rise combustor design with a three-swirler and hybrid injector to improve the smoke emission and lean blow-out characteristics was presented.

高温升燃烧室头部燃烧组织方案设计，以改善高温升燃烧室的贫油熄火边界及冒烟性能。

8·The effects of swirl number of primary swirler and radial swirler, area ratio and sleeve divergence angle on the cold flow field of double swirl air intake were investigated.

试验研究了主、径向涡流器旋流数、面积比、套筒扩张角等参数对双旋流进气装置冷态流场的影响。

9·In this paper the flow field in swirler is measured by five-hole probe, hotwire and LDA. These results could be much the same. It can provide some ideas for design of swirler.

叙述了分别采用五孔探针、热线和激光三种流场测量方法测量旋流器模型内的流场分布情况，并得出基本一致的实验结果，从而为旋流发生器的设计提供理论依据。

10·The numerical simulations of bifurcation phenomena in a combustor with a non slot conical swirler and in a diffuser fixed before the non slot conical swirler have been carried out.

分别对冷态条件下，无隙锥形旋流器燃烧室前扩压器内流场的分叉现象以及燃烧室内燃烧空间的流场分叉现象进行了数值模拟计算。